Flofab RWU series Manual de operação, manutenção e instalação - Página 3

Procurar online ou descarregar pdf Manual de operação, manutenção e instalação para Aquecedor de água Flofab RWU series. Flofab RWU series 11 páginas. Hot water storage tanks

Imprimir página

General Notes and Warnings

For all piping connections, the use and / or type of joint compound or sealer should be determined

by referring to local codes, accepted standards, and / or the requirements of the installing contractor.

An A.S.M.E. approved pressure, or pressure / temperature relief valve, rated higher than the

maximum heat in Btu / hr must be installed. The valve should have a pressure setting no higher

than the maximum design pressure of the tank.

Warnings

As with any tank designed for use as a pressure vessel, the potential exists for severe personal injury

if proper installation and maintenance procedures are not followed. Listed below are specific warnings

pertaining to FLOFAB® Tanks. In addition, throughout this manual, warnings are restated when

procedures are described pertaining to areas of potential danger. All warnings should be carefully

read and understood. All precautions contained in the warnings should be carefully followed to re-

duce the chance of injury.

Note: Throughout this manual, warnings will be denoted by the symbol ▼.

In addition, most components which will be connected to the tank by the purchaser, will be accompa-

nied by their own documentation. This documentation may contain warnings specific to the compo-

nent. It is strongly recommended that each document be reviewed before attempting any installation

or maintenance procedures.

▼ Areas of potential danger:

1. all inlet and outlet lines, joints, and valves;

2. all pressure regulators;

3. all power connections and cables;

4. all energy lines, joints, and valves; and

5. all pneumatic (instrument air) lines and joints.

▼ Before attempting any installation or maintenance procedure:

1. assure that any energy source connected to the system has been turned off;

2. if the unit has been in operation, allow the water in the tank, as well as all components and sur

faces, to cool before starting the procedure;

3. assure that all power has been shut off / disconnected before attempting any procedures; and

4. assure that all inlet and outlet lines have been turned off at the manual shutoff valves.

▼ If the tank will be used for holding hot water, it can present a very dangerous situation due to the

fact it is under pressure and at very high temperatures. To avoid possible injury or death, use

common sense and follow all accepted / recommended procedures when performing installation and

maintenance procedures.

▼ If both electricity and water / steam are to be used in the system, the combination can pose a very

dangerous situation. Assure that all power has been shut off and disconnected before attempting any

installation or maintenance procedures.

I.O.M - HOT WATER STORAGE TANKS - RLU/RWU/RSE

SINCE 1981