FLOJET 4305-502 Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Bomba de água FLOJET 4305-502. FLOJET 4305-502 4 páginas. “quad ii diaphragm” automatic water system pump

Imprimir página

Water

Tank

Do Not Plumb Autofill

to Pump Suction Line

INSTALLATION

STEP 1

Remove shipping plugs from Quad pump ports. Some

water from factory testing may spill out.

STEP 2

Install inlet A and discharge B port connectors. Firmly

push slide clips C forward to lock port connectors

in place.

STEP 3

Slide rubber mounts fully into 4 mounting tracks.

STEP 4

Mount pump vertically, with pump head down or

horizontally in an accessible location. If mounting

vertically, motor up, attach motor mounts first, then

pump head mounts, while supporting weight of pump.

D.C. WIRING

STEP 1

Use 14 gauge stranded wire to 20', 12 gauge to 50',

from power source.

STEP 2

Use a 10-15 amp rated on-off switch on the (+) positive

(red) motor lead.

Water

City Water

Heater

Inlet

Autofill Tank Valve,

Plumb to Tank

Flojet Inlet

Strainer

Red (+)

Fuse

Check

Valve

STEP 5

Use 1/2" I.D. flexible hose (preferably braided or

reinforced). Use hose clamps on the slip-on barb hose

connectors.

STEP 6

Install no less than 3/8" I.D. hose for feed lines to

fixtures. Use high pressure hose on all city water lines.

STEP 7

Install a Flojet strainer in an accessible Location (for

inspection and cleaning) between the tank and pump

inlet. This strainer or equivalent is required for pump

warranty to be valid.

NOTE: Small accumulator tank maybe used for

smoother flow.

Black (–)

Switch

STEP 3

Install 10-15 amp fuse protection on the positive lead for

the -500, -144 and -143 models, use a 7 amp fuse for the

- 503 and -343 and a 4 amp fuse for -501 and -443 models.

NOTE: The 115 and 230 Volt models may be plugged

directly into any ac outlet. A G.Fl. (ground fault interruption)

outlet and switched circuit is recommended.

(+)

(–)

Battery