FLOJET 4325-043 Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Bomba de água FLOJET 4325-043. FLOJET 4325-043 4 páginas. “quad ii diaphragm” automatic water system pump
Também para FLOJET 4325-043: Manual de instruções (4 páginas)

Imprimir página

TankValve,

INSTALLATION

STEP 1

Remove shipping plugs from Quad pump ports. Some

water from factory testing may spill out.

STEP 2

lnstall inlet A and discharge B port connectors. Firmly

p u s h s l i d e c l i p s C f o r w a r d t o l o c k p o r t c o n n e c t o r s

I n p l a c e ,

STEP 3

Slide rubber mounts fully into 4 mounting tracks.

STEP 4

Mount pump vertically, with pump head down or

horizontally in an accessible location. lf mounting

vertically, motor up, attach motor mounts first, then

pump head mounts, while supporting weight of pump.

STEP 5

Use 1/2" LD. flexible hose (preferably braided or

reinforced). Use hose clamps on the slip-on barb hose

connectors.

STEP 6

Install no less than 3/8" LD. hose for feed lines to

fixtures. Use high pressure hose on all city water lines.

STEP 7

Install a Flojet strainer in an accessible Location (for

inspection and cleaning) between the tank and pump

inlet. This strainer or equivalent is required for pump

warranty to be valid.

NOTE: Small accumulator tank maybe used for

smoother flow

Battery

D.C. WRII{G

STEP 1

Use 14 gauge stranded wire 10 2O', 12 gauge to 50',

from power source.

STEP 2

Use a 10-15 amp rated on-off swilch on the (+) positive

(red) motor lead.

STEP 3

Install 10-15 amp fuse protection on the positive lead for

the -500, -144 and -143 models, use a 7 amp fuse for the

- 503 and -343 and a 4 amp fuse for -501 and -443 models.

NOTE: The 115 and 230 Volt models may be plugged

directly into any ac outlet. A G.Fl. (ground fault interruption)

outlet and switched circuit is recommended.