Amcrest AMC4KBC28-B Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Câmara digital Amcrest AMC4KBC28-B. Amcrest AMC4KBC28-B 9 páginas.

6. Operation and Maintenance

Do not touch the camera sensor or lens directly. To clean dust or dirt off the lens, use an air blower or a microfiber

cloth.

7. Accessories

Be sure to use only the accessories recommended by the manufacturer. Before installation, please open the package

and check to make sure that all the components are present. Contact the retailer that you purchased from or Amcrest

directly if anything is broken or missing in the package.

Product Introduction

This series of camera is adopted with CMOS image sensors that provide high performance, high megapixel resolution

that supports 4K video. It supports monitoring signals and audio via a coaxial transmission and standard BNC connection

and built in microphone. Transmission distances can range more than 700m (2296ft) @ 4K. This series can also support

CVI/TVI/AHD/Analog output as well as recognize high speed, long distance, and real time video transmissions.

•

1/2" CMOS (OS08A10)AGC, AWB, AES

•

4K@15fps, 6M@20fps, 4M@30fps

•

2D/3D DNR, Smart IR Control

•

DC12V, 2.0A

Before physically installing your camera, make sure the mounting surface can support up to 3x the weight of the

camera.

Locate the position in which you would like to place your camera and using the base of the camera, mark the 4

installation holes with a marker onto the mounting surface. These holes will be used to drill the holes needed to mount

your camera.

Using a drill bit that is the same diameter or slightly smaller diameter than the included drywall wall anchors, drill

the 4 holes and insert the wall anchors into the holes.

Note: The wall anchors should be in the same bag as the screws and a designed to secure the screws onto the mounting

surface.

Attach the power cable and BNC cabling to the camera. (If you are running the cables through a mounting surface,

use a 1" paddle bit to bore a hole for the cables.)