AMD SB710 Manual do utilizador - Página 12
Procurar online ou descarregar pdf Manual do utilizador para Placa-mãe AMD SB710. AMD SB710 19 páginas. Based m/b for socket am2/am2+/am3 series quad core processor
Também para AMD SB710: Manual do utilizador (20 páginas), Manual do utilizador (20 páginas)
Imprimir página(2) ATX 12V Power Connector (4-pin block): ATX12V
This is a new defined 4-pins connector that usually comes with ATX Power
Supply. The ATX Power Supply which fully supports AMD AM3 processor must
including this connector for support extra 12V voltage to maintain system power
consumption. Without this connector might cause system unstable because the
power supply can not provide sufficient current for system.
(3) PS/2 Mouse & PS/2 Keyboard Connector: KB
The connectors are for PS/2 keyboard and PS/2 Mouse.
(4) USB Port connector: CN5/ UL1 for USB
The connectors are 4-pin connector that connects USB devices to the system
board.
(5) LAN Port connector: UL1 for RJ-45 LAN
The connector is standard RJ45 connector for Network. It supports 10M/100Mb
data transfer rate.
( 6)
Audio Line-In, Line-Out, MIC Connector: CN3
These Connectors are 3 Phone-Jack for LINE-OUT, LINE-IN, and MIC audio
connections.
Line-in: (BLUE)
Line-out: (GREEN)
MIC: (PINK)
PS/2 Mouse
PS/2 Keyboard
(7) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard
disk(s). If you install two hard disks, you must configure the second drive to Slave
mode by setting its jumpers accordingly. Please refer to the documentation of your
hard disk for the jumper settings.
2
GND
+12V
4
ATX12V
Audio input to sound chip
Audio output to speaker
Microphone Connector
VGA Connector
9
Pin1
GND
+12V
3
RJ-45 LAN
USB Connector
Line-IN
Line-OUT
MIC-IN