Ameda MyaJoyPlus Manual de instruções de utilização - Página 5
Procurar online ou descarregar pdf Manual de instruções de utilização para Bomba tira-leite Ameda MyaJoyPlus. Ameda MyaJoyPlus 20 páginas. Double electric breast pump
Imprimir página
TO BEGIN PUMPING
1
STEP 1: INSERT TUBING
Insert Tubing adapter into the right side of
the pump base, then turn the pump slightly
to the right, and gently push it to make sure it
connects firmly.
A. For DOUBLE PUMPING: Both tubes should
be attached to the tubing adapter.
B. For SINGLE PUMPING: Remove one tube
from the tubing adapter and close one side
using the attached plug.
4
5
6
7
Questions? Visit www.ameda.com or call us at 866.992.6332
2
STEP 2: PLACE THE
FLANGE ON BREAST
Center flange on breast to create seal.
Check breast flange fit, if pumping
causes discomfort, a larger or smaller
breast flange size may be needed.
See section on how to properly fit
your flange.
See section below on how to properly
fit your flange.
STEP 4: ADJUST VACUUM LEVEL
Adjust the Stimulation Vacuum Level between 1 and 6 to your preferred comfort level.
Never set to uncomfortable level.
TIP: Start off with the suction low, and then gradually increase the suction setting to your
most comfortable level. You may find that the level of suction that you are comfortable with
varies from day to day, during the day and even during the same expression session.
NOTE: After two minutes, the pump will automatically switch to Expression
Mode unless you manually adjust prior.
STEP 5: CHANGE MODE
Once your milk starts to flow, press the Mode button to switch into Expression Mode.
STEP 6: ADJUST VACUUM LEVEL
Adjust the Expression Vacuum Level between
1 and 12 to your preferred comfort level. Never set to uncomfortable level.
TIP: Start off with the suction low, and then gradually increase the suction setting to your
comfort level. You may find that the level of suction that you are comfortable with varies
from day to day, during the day and even during the same expression session.
STEP 7: END PUMPING SESSION
When you wish to stop expressing milk, first press the Power button, then remove milk
collection kit from your breast.
TIP: After pump is off, if necessary, INSERT a finger between breast and breast flange
to break suction.
3
STEP 3: POWER
ON THE PUMP
Press the Power button
to turn on the device.
It will begin in Stimulation
Mode.
5