10Bar E-500 Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Acessórios para câmaras 10Bar E-500. 10Bar E-500 12 páginas. Camera housing

•

IF THE O-RING IS DAMAGED OR SUSPECTED OF BEING DAMAGED, DISCARD

IMMEDIATELY. A spare O -ring is supplied with your housing, or a replacement O-

ring can be obtained from 10 BAR. If the O-ring is contaminated or suspected of being

contaminated, clean it with a cotton cloth that is free of loose fiber, chemicals or

contamination. After cleaning inspect the O-ring again.

• Once the O-ring has been inspected and verified fit for use, apply a

silicone grease to the O-ring. The silicone grease must be evenly distributed round the

O-ring.

• Replace the O-ring into the groove; run a finger round the O-ring, to make sure it is

snugly seated in the groove.

(Fig. 4) Stretch the O-ring

4.7 Mounting the camera in the housing:

Remove the lens cap and wrist strap. The pressure release plug should be pulled out

before inserting the camera. Attach the plastic slide tray to the camera's tripod mounting

fixture with a coin, screwdriver or the end of the universal tool supplied (Fig. 5). Take care

not to excessively tighten the screw. Attach the zoom gear guide on the lens zoom bezel with

the mounting Velcro (Fig. 6), pointing the guide right into the slot of the gear ring on housing

bezel (Fig.7). Pull up the Main Dial control button. Slide the camera into the body along the

guide rail and make sure the zoom gear guide coupled with the slot of the gear ring on the

lens bezel (Fig. 8). Make sure the camera body reach the limit and test the function of the

on/of button on the body of the housing. Slide the hot shoe plug into the hot shoe (Fig. 9)

Note: If you find that the buttons do not align properly with the controls, please check again

that the camera is properly seated to the limit of the guide rail.

SMALL

amount of

9/6/2006