Coalesse SW 1 Instruções do serviço de apoio ao cliente - Página 6
Procurar online ou descarregar pdf Instruções do serviço de apoio ao cliente para Mobiliário de interior Coalesse SW 1. Coalesse SW 1 7 páginas. Replacement of knit and fabric components
Também para Coalesse SW 1: Manual (11 páginas)
Imprimir página
Yoke to Base Alignment (Swivel Return Cylinders)
NOTE: When servicing seating with swivel return cylinders, check
to ensure that the arm yoke is aligned properly with the base. The
arm yoke should be aligned evenly between the "X" angle of the
base legs, as noted below.
1
.
If the yoke is not in alignment with the base and removal is
necessary, stand at the back of the chair and place both feet on
the outer ends of the nearest base legs.
2
.
Grasp both ends of the arm yoke and pull up while rocking the
yoke side to side, to dislodge it and the cylinder from the base.
3.
Disengage the yoke and cylinder from the base and then allow
this assembly to rest loosely in the base.
4.
Tilt the base and yoke together, backwards, until it is resting
on two (2) of the base legs and the arm yoke ends, on the floor.
This will align the yoke properly with the base.
5.
Hold the yoke and cylinder and strike the base with a soft blow
mallet to reseat the cylinder into the the base.
CORRECT ALIGNMENT!
TOP VIEW
(Seat plate not shown for clarity)
INCORRECT ALIGNMENT!
2
3
1
4
5
Page 6 of 7
1070628001 Rev A