Coalesse SW 1 Table Manual - Página 9
Procurar online ou descarregar pdf Manual para Mobiliário de interior Coalesse SW 1 Table. Coalesse SW 1 Table 11 páginas.
Imprimir página
14.
Use a 5mm allen wrench or
provided bit to snug the connector
(not completely).
Feel top surface of seam, then use a
rubber mallet near connector to raise
the low side. Secure the connectors.
15.
Repeat this procedure across
length of the seam from one side of
the table to the other. Carefully tap
halves flush, then secure Zipbolts.
16.
Recheck to be sure that the
table halves are flush along the
seam. If adjustment is needed,
loosen the Zipbolt connectors, flush
the top, then retighten them.
17.
Secure this half to the cones
following the same method as step 9.
NOTE: If cone does not sit down
in the pocket, loosen lock nut on
base column to allow cone to slide
into pocket. Retighten hex nut
from the bottom to 30 ft-lbs
before securing.
18.
Adjust threaded leveling
glides as needed.
8
17
15
1
2
3
4
5
6
7
Use caution when using mallet to
minimize risk of damage.
Never use mallet on worksurface top.
Tap from underside of table.
14
Tighten to 10 + 1.5 in-lb torque.
16
18
LEVELING GLIDES
Page 9 of 11
939500440 Rev E