aero pure AP120-S Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Ventilador aero pure AP120-S. aero pure AP120-S 4 páginas. Ventilation fan
Também para aero pure AP120-S: Manual (5 páginas)

Imprimir página

ASSEMBLY INSTRUCTIONS

5. INSTALL DUCTWORK

Connect the round ductwork (not included) to the damper/duct connector,

and run the ductwork to a roof or wall cap (not included). Using duct tape

(not included), secure all the ductwork connections so that they are air tight

Insulated flexible duct is recommended for the quietest possible installation.

If rigid duct is used, a short (1-3 feet) section of insulated flexible duct will

ensure quiet operation.

The ducting from this fan to the outside of building has a strong effect on

the air flow, noise and energy use of the fan. Use the shortest, straightest

duct routing possible for best performance, and avoid installing the fan with

smaller ducts than recommended. Insulation around the ducts can reduce

energy loss and inhibit mold growth. Fans installed with existing ducts may

not achieve their rated air flow.

CONNECT ELECTRICAL WIRING

Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to

the wiring plate. Refer to the wiring diagram and connect the wires as shown.

FOR AP120-S

FOR AP120H-S

INSTALL GRILLE

Install ceiling material to complete the ceiling construction. Then cut around

the fan housing.

To attach the grille assembly to the fan housing, pinch the grille springs on

the sides of the grille assembly, and position the grille into the housing

with the grille springs in the appropriate slots. Gently push the grille

assembly towards the ceiling to secure.

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner

Aero Pure AP 120-S, AP120H-S