10Bar GF1 Manual do utilizador - Página 8
Procurar online ou descarregar pdf Manual do utilizador para Acessórios para câmaras 10Bar GF1. 10Bar GF1 9 páginas. Underwater housing for the panasonic gf1 camera
Imprimir páginaThe control levers and push buttons consist of internal double O-ring seals on a
stainless steel shaft.
operating the controls, avoid
This arrangement is very reliable, however as a precaution, when
excessively rapid movements, as this may distort the O-ring. Also please allow for the fact that the
camera takes a few seconds to power on. If the camera dose not appear to respond to a control
action, make sure that no other controls are pressing on the camera, i.e. locking out further
actions.
Wear the wrist strap; it is easy to inadvertently let go of the housing, especially if you are
distracted.
5.3 Cleaning & Storage.
The body & lid of the housing are made of 6061 Aluminium and Acrylic respectively. 6061
Aluminium is selected for its outstanding strength stiffness, hardness and toughness, While
Acrylic for its crystal clear transparency and high gloss surface. Both of them have good
resistance to weathering, although long-term exposure to sunlight should be avoided. Normal
operating temperature range is 3°C to 36°C (Storage temperature: -10°C to 50°C)
It is good practice to rinse off your housing with fresh water after every dive. Avoid to exposure to
fine sand. After a series of 10 or more dives, e.g. after a dive holiday, it is recommended to
immerse the housing for 2-3 hours in warm water to dissolve any salt deposits that may have built
up. No chemical cleaners should be used.
Important
: For long term storage please remove the main closure o-rings from body.
5.4 Transportation.
Please protect the housing during transportation. It is recommended to remove the handle, and
shutter extension, and wrap the camera in foam or bubble wrap.
5.5 Accidents
The impact resistance of the housing is excellent. However after an accident thealignment of the
housing may have been altered. Therefore in the event of your housing suffering an impact force,
e.g. being dropped, it is essential that you do not use the housing for diving. Please return the
housing immediately for service and put a note inside to indicate the nature of the accident, so
that the severity can be assessed.
6. Service
To ensure the continued performance of your housing, it should be serviced every year, or after
every 200 dives whichever is earlier. Please note the terms for servicing the housing posted at our
website. A full service will include:
necessary),
Inspect all components for wears or damage (report if repair
Clean all sealing surfaces,
Replace all O-ring seals,
8