10Bar Underwater Housing Manual do utilizador - Página 13

Procurar online ou descarregar pdf Manual do utilizador para Acessórios para câmaras 10Bar Underwater Housing. 10Bar Underwater Housing 16 páginas. Underwater housing for olympus e-pl2
Também para 10Bar Underwater Housing: Manual do utilizador (15 páginas)

Imprimir página

Inspection, Cleaning and Re-installation of the O-rings

Tools

Soft cotton buds that are free of chemicals or contaminants such as loose fibers.

Silicone grease supplied with the housing or other types of silicone grease specifically for underwater

camera equipment can also be used.

Procedure

The following procedure should be carried out on a clean, firm, level surface (e.g., on a table) to prevent

slipping especially when diving from a boat.

The O-ring can be extracted using the O-ring extractor tool that came with the housing, or push with

the flats of both thumbs or index fingers to gently stretch the O-ring on two adjacent sides thus

making a small loop protruding around the corner. The loop can then be grasped and the O-ring pulled

over the lip.

Clean the O-ring recess (the square groove where the O-ring sits) with a cotton bud.

Inspect the surface of the O-ring for contaminants and damages such as cuts or tears. This should be done

visually and by running the O-ring between thumb and index finger, sensing any textural abnormalities on

the surface.

If the O-ring is damaged or suspected of being damaged, discard it immediately.

Spare O-rings are supplied with your housing, or replacement O-rings can be ordered from 10Bar.

If the O-ring is contaminated, clean it with a clean cloth.

Re-inspect the O-ring after cleaning.

Once the O-ring has been inspected and verified good for use, apply and distribute evenly a SMALL

amount of silicone grease to the surface of the O-ring.

Replace the O-ring into the groove.

Run a finger over the O-ring to make sure it is seated properly.