Acer AL1911 Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Monitor Acer AL1911. Acer AL1911 10 páginas. Acer monitor user guide

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-2.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches

threaded nuts, as well as four 5 mm access holes in the plastic covering

as illustrated in Figure 1-3. These specifications meet the VESA Flat

Panel Monitor Physical Mounting Interface Standard (paragraphs

2.1 and 2.1.3, version 1, dated 13 November 1997).

Note :Please using Ø 4mm x 8mm (L) screw for this application.

Please follow these instructions to install the cables.

1. Remove the back panel

2. Place the signal cable, the audio cable into their correct socket.

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor's VGA port.

(See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port on your

PC.

4. Make sure connections are secure.

Attention: This device must be connected to an off-the-shelf video cable in order to comply with FCC

regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

1. Connect the power cord to the AC socket. (See Fig. 1-6)

2. Connect the power cord to an AC power source.

1. Connect the audio cable to the "LINE OUT " jack on your PC's

audio card or to the front panel's "AUDIO OUT" jack of your CD

ROM drive. (See Fig. 1-7)

2. Connect the other end of the audio cable to the LCD Monitor's

"LINE IN" jack.

from the rear of the monitor.(See Fig. 1-4)

Figure 1-3

Figure 1-4

Figure 1-5

Figure 1-6

Figure 1-7