aero-naut Dassault Breguet Rafale C 01 1358/00 Instruções de construção - Página 5

Procurar online ou descarregar pdf Instruções de construção para Brinquedo aero-naut Dassault Breguet Rafale C 01 1358/00. aero-naut Dassault Breguet Rafale C 01 1358/00 8 páginas.

Imprimir página

Dassault Breguet Rafale C01

The wings can now be glued to the front fuselage section (1) and the root facing ribs (14 + 15). Apply two layers

of 80 g glass cloth and resin to the joint area between the wing panels and the front fuselage section (1). Apply

filler to the joint lines very carefully; these areas should not be sanded to avoid damaging the structural cloth.

13) Cockpit + canopy

Cut out the canopy frame (24) and the cockpit insert (25), and glue the insert to the underside of the frame. The

pilot's seat (26) consists of two parts which have to be cut out and glued together; add a piece of scrap wood to

complete the backrest. The cockpit insert (25) will need to be cut away under the seat to clear the nosewheel.

Glue the seat in place, fit the (optional) pilot figure and glue him to the seat.

The canopy frame (24) is retained in the front of the fuselage (1) by the beech dowel (27). Glue two pieces of 3

mm scrap wood together and trim them to fit in the front of the canopy frame. Drill a hole through the wooden

parts and the fuselage to accept the dowel (27). Glue the dowel to the wood block, then glue the dowel assembly

to the canopy frame.

Cut out the canopy moulding (23), trial-fit the canopy latch (28) and glue it in place. Drill a hole in the fuselage to

accept the canopy latch pin.

Glue the canopy (23) to the canopy frame (24).

14) Jet efflux

Screw the ducted fan unit to the motor bulkhead (68), and tape the efflux (71) to the rear of the unit before

attaching the rear fuselage section (2).

Building instructions - Rafale C 01 - Aramid