aero-naut Princess Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Brinquedo aero-naut Princess. aero-naut Princess 17 páginas. 3081/00

The next step is to trim the side stringers 20 + 21 to fit against the

keel 12 and glue them in place. Press the strips into the notches in

frame 11.

When the glue has set hard, glue the stringers 20 in the notches in

frames 1 - 11.

Note that the side stringers 20 must be pressed fully into the

notches in the frames, especially where they meet frame 11 at the

bow. Secure the stringers with modelling pins.

When the glue has set hard, glue the stringers 21 in the notches in

frames 7 - 11. Pin the parts in place.

Tape the side panels 23 together at the front, applying

the tape on the mahogany side, i.e. the bevelled light-

coloured surface on the inside. The two side panels can

now be glued to the hull, from the centre of the keel 12

to the stern frame 1. Start at the bow, and fix the side

panels in place with spring clamps and pins. The side

panels 23 must rest on the jig tabs of frames 1 - 11 and

on the jig tab of the keel 12 at the bow.

Wipe off excess glue immediately using a damp cloth.

Seal the mahogany face of the side panels 23 with a coat of

sanding sealer, and allow it to dry for about twelve hours. Sand

the front end of the side panels 23 at an angle (arrow) on the

light-coloured inside face, so that they form a sharp front edge

when glued to the keel 12 (see Stage 13); see arrow.

Caution: take care to bevel the inside face of each panel, i.e.

one left, one right!