Aktakom ASE-1107 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Pistola de soldar Aktakom ASE-1107. Aktakom ASE-1107 15 páginas.

B. Connections

1. Connect the cord assembly into the

receptacle.

2. Place the soldering iron in the iron

holder.

3. Plug the power cord into a power

supply. Be sure to ground the unit.

4. Turn the power switch to on.

The temperature is preset at 750°F at

the factory.

The heater lamp flickers when the

temperature has stabilized.

5. Press the * button to display the preset

temperature. It will be display for two

seconds.

C. Set the Temperature

CAUTION! Be sure to insert the correct end of the card into the card slot. While setting

the temperature, the power supply to heating element is off.

Example:

°F to

750

660

7 5 0

↓

7 5 0

↓

6 5 0

↓

Press

°F

Insert the card

button once

1. Insert the card into the card slot in the station.

The left-most digit (the 100's digit) in the

display will flash. This indicates that the

station is in temperature setting mode and that

the 100's digit can be adjusted.

2. Select the desired value for 100's digit. Using

the "up" or "down" button will change

displayed value as follows.

Press the "*" button when the desired value is

displayed.

This will cause the middle digit (the 10's

digit) in the display begin flashing.