Acer AL2416W Manual do utilizador - Página 15

Procurar online ou descarregar pdf Manual do utilizador para Monitor Acer AL2416W. Acer AL2416W 15 páginas. Value line
Também para Acer AL2416W: Especificações (2 páginas)

Imprimir página

Troubleshooting

This LCD Monitor has pre-adjusted using factory standard VGA timings. Due to the output timing

differences among various VGA cards in the market, users may initially experience an unstable or

unclear display whenever a new display mode or new VGA card is selected.

Attention

This LCD Monitor Supports Multiple VGA Modes.

Refer to the Standard Timing Table for a listing of modes supported by this LCD Monitor.

PROBLEM Picture is unclear and unstable

The picture is unclear and unstable, please perform the following steps :

1. Enter PC to "Shut Down Windows" status while you're in MS-Windows environment, except

Windows XP. In Windows XP open the specific application where the problems appear.

2. Check the screen to see if there's any black vertical stripes appear. If there are, take advantage of the

"Clock" function in OSD menu and adjust (by increment or decrement numbers) until those bars

disappear.

3. Move to "Phase" function in OSD menu again and adjust the monitor screen to its most clear

display.

4. Click "No" on "Shut Down Windows" and back to the normal PC operating environment.

PROBLEM There is no picture on LCD Monitor

If there's no picture on the LCD Monitor, please perform the following steps:

1. Make sure the power indicator on the LCD Monitor is ON, all connections are secured, and the

system is running on the correct timing. Refer to Chapter 3 for information on timing.

2. Turn off the LCD Monitor and then turn it back on again. If there is still no picture, press the

Adjustment Control button several times.

3. If step 2 doesn't work, connect your PC system to another external CRT. If your PC system

Functions properly with a CRT Monitor but it does not function with the LCD Monitor, the output

timing of the VGA card may be out of the LCD's synchronous range. Please change to an

alternative mode listed in the Standard Timing Table or replace the VGA card, and then repeat steps

1 and 2.

PROBLEM There is no picture on LCD Monitor

If you have chosen an output timing that is outside of the LCD Monitor's synchronous range

(Horizontal: 24 ~ 80 KHz and Vertical: 49 ~ 75 Hz), the OSD will display a "Out of Range" message.

Choose a mode that is supported by your LCD Monitor.

Also, if the signal cable is not connected to LCD monitor at all or properly, the monitor screen will

display a message "No Input Signal".