Aktobis AG WDH-520EB Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Desumidificador Aktobis AG WDH-520EB. Aktobis AG WDH-520EB 12 páginas.

Instructions for use:

Commissioning

1.1 Insert the mains plug properly into the socket.

1.2. Check that the condensation tank is properly seated in the dehumidifier. (When using the

dehumidifier for the first time, the "condensation tank full" light may come on. Simply pull the

condensation tank out briefly and then push it right back in and you are ready to go).

1.3 Switch on the unit with the power switch. Now press the humidity setting button and set your target humidity as desired. The

target value of 30% humidity actually corresponds to continuous operation ! The value you set must be below the current

room humidity for the unit to dehumidify. If your value is above the current room humidity, the fan runs for 3 minutes and the

unit then switches off. If the room humidity rises above the set value, the unit automatically starts dehumidifying again.

1.4 Select between a low and a high fan strength / air circulation with the "FAN" button.

1.5 If you want to activate/use the timer function (function for determining the remaining time or function for specifying a start

time), press the TIMER key.

Determining the remaining running time: Press the TIMER button during operation to select the desired remaining running

time of the dehumidifier. (A value between 1 - 12 hours can be selected). After this selected operating time has elapsed, the

unit switches off automatically.

Determining a start time: When the dehumidifier is switched off, press the TIMER button to select the desired start time. (A

value between 1 - 12 hours can be selected). After this selected time has elapsed, the appliance switches on automatically

(with the last settings used, provided the mains plug has not been disconnected in the meantime).

Emptying the collection tank / When the "Bucket Full" light is on

When the condensation tank is full, the signal light lights up and the dehumidifier then automatically

stops its dehumidification operation. Remove the condensation tank and empty it. After you have

pushed the condensation tank neatly back into the unit, the dehumidification operation starts again

automatically.

Connecting a hose

3.1. You will need a ½ inch plastic hose.

3.2. Briefly remove the condensation tank and push out the pre-punched plastic cover (connection point for

drain hose) with a large screwdriver.

3.3. Pass the plastic hose through the rear opening and then connect it to the drip tap (see diagrams below). Then push the

condensation tank neatly back into the appliance.

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de