Air & Allied Sales UGC3005 Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para Pulverizador de tinta Air & Allied Sales UGC3005. Air & Allied Sales UGC3005 10 páginas. Solvent based spray gun cleaner

Imprimir página

Unic International (UK)

Health & Safety Data Sheet

Information supplied in accordance with section 6 of the health and safety at work etc. Act 1974

PRODUCT NAME

USES

GENERAL

PRECAUTIONS

FIRE HAZARDS

HEALTH HAZARDS

VENTILATION

PERSONAL

PROTECTION

EQUIPMENT

WASTE DISPOSAL

EMERGENCY

ACTION

SUPPLIER

INFORMATION

[email protected]

UNIC POWERCLEAN SPRAY GUN CLEANING UNIT.

Removal of paint from Spray guns, cups and hoses.

Before operating Powerclean Spray Gun Cleaning System, operators must be

familiar with the correct operating procedures as detailed in the manufacturer' s

Operating Manual.

Do not tamper with the safety lid switch, which prevents the unit operating in the

cleaning mode when the lid is open.

Close drain valve and close lid when the unit is not in use. All solvent should be

drained from the cleaning tank before closing the drain valve.

Inspect solvent storage compartment daily to ensure there is no leaks from the

solvent containers.

Replace solvent lter pad frequently (bimonthly replacement of the lter pad is

recommended)

Always disconnect the air source before performing maintenance tasks.

Do not smoke or use other ignition sources near the cabinet.

E.g. no hot work, such as welding.

The cleaning solvent used will contain substances hazardous to health, typically

acetone, methanol, white spirit, xylene and toluene. Air monitoring carried out

with a recommended cleaning thinner has shown that concentrations do not

exceed exposure limits published by the Health and Safety Executive. Levels

were less than 50% of the mixed short-term exposure limit when the lid was

open for removal of the spray gun, cups and hoses and just 6% of the limit

during the cleaning cycle. Substances in the solvent however can be absorbed

through the skin, see personal protection equipment.

A local exhaust ventilation system as supplied with the machines, should be

installed so that vapours are safely vented to atmosphere away from windows

and other air inlets. In accordance with the Control of Substances Hazardous to

Health regulations 1988 the system should be maintained and undergo a

thorough examination.

Suitable gloves must be worn when replacing and removing spray guns from the

cleaning machine. Most glove manufacturers recommend Nitrile gloves for the

solvent xylene and toluene, which can be absorbed through the skin.

Waste solvent must be removed by a registered carrier to a disposal or recovery

facility licensed to receive waste solvent.

FIRE

In case o re, use a form of dry powder extinguishing agent. Cool solvent drums

exposed to re with water spray.

FIRST AID

Eye contact with solvent- irrigate with clean water. Skin contact with solvent-

remove contaminated clothing, wash skin thoroughly with soap and water.

Excess inhalation of solvent vapours – Remove to fresh air, seek medical

attention

Accidental Ingestion – Do not induce vomiting, seek medical attention.

SPILLAGE OF SOLVENT

Contain and collect with non-combustible materials E.g. sand and earth. Do not

allow to enter drains. Exclude sources o gnition. Ventilate area.

Unic International (UK)

Air & Allied Sales (Pacific) Pty Ltd