Barnett Scorpion 608-30-10086 Manual de instalação - Página 2
Procurar online ou descarregar pdf Manual de instalação para Acessórios para motociclos Barnett Scorpion 608-30-10086. Barnett Scorpion 608-30-10086 2 páginas.
Imprimir páginaWARNING!
Always wear proper eye protection when removing or
installing snap rings. Slippage may propel the ring with
enough force to cause eye injury. Use correct retaining
ring pliers. Verify that the tips of the pliers are not
excessively worn or damaged.
Installing Your Scorpion
2. Install snap ring into rear of Barnett Scorpion hub; make
sure the snap ring is correctly embedded in the snap ring
groove.
3. Check key way and slots for wear or distortion.
Replace if necessary. Refer to photo 3.
4. Re-Install the clutch basket into the primary case (with
chain and the associated components) using red thread
lock on the transmission main shaft prior to installing the
clutch hub nut. Tighten the hub nut using the factory
torque specifications (50-60 foot lbs) as instructed in your
factory manual. Refer to photo 4.
5. Presoak friction disks in primary lubricant for approxi
mately ten minutes. Wipe dry with lint-free towel prior to
installation.
Clutch
™
Photo 3
Photo 4
6. Starting by installing a steel plate first; friction plate next,
following with steel, friction, steel, friction, ending with
steel plate last.
7. Install the pressure plate using (6) six MT-7 springs; (6)
six spring cups and (6) six- 6mm SHCS.
8. Torque 6mm screws to 5 ft. lbs.
9. Adjust clutch per factory manual, using a center bolt
adjuster. Refer to photo 5.
10. Check and adjust primary chain as needed. Re-install
outer primary cover and pour proper amount and type of
primary case lubricant through the clutch inspection
opening.
11. Using a new O-Ring, install clutch inspection cover in
chain case cover. Install (3) three socket screws using
new rubber sealing washers. Tighten screws to 50-70
inch lbs.
12. Re-install shifter lever, foot pegs, floorboards, etc.
Clutch spring pressures
Springs
MT-7-6
MT-23-6
MT-91-6
Using 3 ea. MT-7 and
3 ea. MT-23
805.642.9435
2238 Palma Drive
www.barnettclutches.com
Photo 5
lbs of Spring Pressure
348
492
600 lbs.
420
fax 805.642.9436
•
Ventura, CA 93003-5733
•