American Standard Chandler 7048.401 Instruções de instalação
Procurar online ou descarregar pdf Instruções de instalação para Mobiliário de interior American Standard Chandler 7048.401. American Standard Chandler 7048.401 2 páginas. W/drainboard double bowl sink
Também para American Standard Chandler 7048.401: Ficha de especificações (2 páginas)
Imprimir página
Installation Instructions
CHANDLER™ KITCHEN SINK
w/DRAINBOARD
MODEL 7048.401 RIGHT HAND DRAIN BOARD
MODEL 7048.501 LEFT HAND DRAIN BOARD
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
BEFORE YOU BEGIN...Unpack new sink and
inspect carefully for damage. Replace the sink
in its original packing carton to protect it until
you are ready to begin installation.
Recommended Tools & Materials
Putty Knife
Pipe Wrench
Channel Locks
Phillips Screwdriver
Regular Screwdriver
Adjustable Wrench
Drill
AFTER THE CUTOUT IS DRAWN...
1
Drill a clearance
hole inside the
cutout line
as marked on
the countertop.
NOTE: The drain-
board is not
part of the cut
out and sits above the countertop.
2
Cut opening on
cut line inside the
perimeter of bowl
shape.
3
Mount the faucet
and drain assembly
on the sink
following the
manufacturer's
instructions.
Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.
®
Corian
Dupont registered trademark
™
Basin Wrench
Saber Saw
Plumbers' Putty or
Caulking
Tubing Cutter
Tape Measure
Hacksaw
Perimeter
of sink
Cutout
Perimeter
of sink
Cutout
Right Hand Shown
Certified to comply with ANSI Z124.6
Observe local plumbing and building codes.
CUTOUT DIMENSIONS FOR SINK
Locate and mark center lines of sink on countertop.
Provide proper clearance under the countertop for
the faucet supply lines and the structural parts of the
cabinet.
By using the diagram below and measuring your sink,
draw the outline of the sink onto the countertop. This
is not the cutting outline.
CUTOUT FOR NEW INSTALLATION
32"
10-1/2"
21"
CUTTING
LINE
(SHADED
AREA)
MODIFICATION REQUIRED TO FIT CHANDLER SINK
INTO A STANDARD 33" X 22" SINK CUTOUT
NOTE: ALLOW ROOM ON EITHER SIDE OF SINK
DEPENDING ON RIGHT OR LEFT HAND DRAIN BOARD
10-1/2"
19-1/2"
CENTER LINE
CUTTING
LINE
Right Hand
Drain Board
Left Hand
Drain Board
7 9 0 7 6 0 - 1 0 0
49-1/2"
35"
RIGHT
HAND
DRAIN
BOARD
1/2"TYP.
C/L OF
SINK
DOUBLE
OUTLINE
BOWL
35"
1-1/2"
21"
32"
19-1/2"
© American Standard Inc. 2000
22"