American Standard Portsmouth 9210.030 Instruções de montagem/instalação - Página 3
Procurar online ou descarregar pdf Instruções de montagem/instalação para Mobiliário de interior American Standard Portsmouth 9210.030. American Standard Portsmouth 9210.030 14 páginas. 30" vanity
Imprimir página
PORTSMOUTH VANITY SINK 7820.400 AND 7820.800
INSTALLATION onto VANITY
Two people recommended for this installation
A
Mount the drain assembly (not included) on the sink. Be certain to apply
a bead of sealing putty on the underside of the drain (Part "A") in order to ensure
a watertight seal between the sink and drain. Remove excess putty after installing
the drain on the sink.
Apply a bead of silicone adhesive to the rim of the vanity. Place the top centered
left to right on the vanity and with the back edge of the top even with the rear of
the vanity. Apply a bead of silicone along the top back edge of the vanity top
and the wall. Clean up any excess silicone.
Connect the trap to the drain assembly hand tight to check alignment. It may be necessary
C
to cut off part of the tailpiece (area "B") or part horizontal leg of the trap (area "C").
B
Connect hot and cold supply lines to the shut off valves.
Tighten trap joints for watertight assembly.
MARBLE TOP 9210.130 WITH PORTSMOUTH 0615 UNDERCOUNTER SINK
Two people recommended for this installation
NOTE: Marble top comes pre-cut for the Portsmouth Undercounter sink and 8"
A
faucet spread. Also it is strongly recommended that the marble top be sealed after
installation and prior to use.
Mount the drain assembly (not included) on the sink. Be certain to apply a bead of
sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal
between the sink and drain. Remove excess putty after installing the drain on the sink.
Turn the marble top upside down and place it on a clean, scratch
resistant surface. Apply a bead of silicone adhesive to the rim of
the sink. Center the sink over the cutout and (secure it to the top
using the mounting kit provided).
NOTE:
Use the 4 brackets supplied with the sink mounting kit
and the 4 screws supplied with the marble top to secure the sink to
the underside of the marble top.
Turn the top right-side up and install the faucet per the manufacturer's instructions.
Apply a bead of silicone adhesive to the rim of the vanity. Place the marble top
centered left to right on the vanity and with the back edge of the top even with the
B
rear of the vanity. Clean up any excess silicone.
A
Connect the trap to the drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "A") or part horizontal leg of the
trap (area "B").
Connect hot and cold supply lines to the shut off valves. Tighten trap joints for
watertight assembly.
77 0 01 1 -1 0 0 R ev. C
- 3 -