American Standard Ranaissance El Total Toilet 2446 Instruções de instalação - Página 4

Procurar online ou descarregar pdf Instruções de instalação para Mobiliário de interior American Standard Ranaissance El Total Toilet 2446. American Standard Ranaissance El Total Toilet 2446 5 páginas. American standard renaissance el total toilet installation instructions

Imprimir página
INSTRUCTIONS TO INSTALL TOILET SEAT
12a
Place seat on bowl. Be careful to
center hinge over holes in bowl.
12d
Use a screwdriver to tighten bolt.
13
NOTE: Pictures are representative and may not
exactly depict the flush valve.
LIFT ARM
FIRST
IMPORTANT: Always
clear sand and rust
from system.
• Make sure water supply
is off. Remove valve TOP
by lifting arm and rotating
top and arm 1/8 turn
counterclockwise, pressing
down slightly on cap.
GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and
workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.
Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster
shall not be responsible or liable for any damages caused by products used with Fluidmaster valves
that were not manufactured by Fluidmaster, Inc.
12b
Insert bolts in hinges.
12e
• While holding a
• Replace TOP by engaging
container over the
lugs and rotating 1/8 turn
uncapped VALVE to
clockwise. MAKE
prevent splashing, turn
CERTAIN TIP IS TURNED
water supply on and off
TO THE LOCKED
a few times. Leave
POSITION. VALVE MAY
water supply off.
NOT TURN ON IF TOP IS
NOT FULLY TURNED TO
THE LOCKED POSITION.
Close the hinge covers.
IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK
SLOWLY, repeat Step 13.
IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF
NON-USE, it is a signal you are wasting water because:
• The end of the refill tube is inserted into overflow pipe, below
water level in tank. Attach refill tube to overflow pipe using "S"
clip provided.
• The flush valve is leaking because it's worn, dirty or misaligned
with tank ball or flapper (replace with a new flapper).
IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL
OF TANK WATER IS SLOW after valve has been in use for
some time, Fluidmaster Model 242 Replacement Seal may be
needed.
Go to our website at www.fluidmaster.com for more
solutions to toilet problems.
For troubleshooting information please contact:
- 4 -
12c
Attach the nut from below.
12f
TOILET SEAT CARE AND CLEANING
When cleaning your toilet seat wash it
with mild, soapy water: rinse the seat
thoroughly with clear water: and dry
with a soft cloth.
Avoid detergents, disinfectants, or
cleaning products in aerosol cans.
NEVER use abrasive scouring powders
on your seat. Some bathroom
chemicals and cosmetics may damage
the seat's finish. After installation, check
the tightness of the bolts from time to
time to ensure a tight fit.
TROUBLESHOOTING
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675
(949) 728-2000 (800) 631-2011
www.fluidmaster.com
© 2001 Fluidmaster, Inc.
® Registered trademark of Fluidmaster, Inc.
7301186 -1 0 0 Re v. B