American Standard Standard Console Table 7483.295 Instruções de montagem e instalação - Página 3
Procurar online ou descarregar pdf Instruções de montagem e instalação para Mobiliário de interior American Standard Standard Console Table 7483.295. American Standard Standard Console Table 7483.295 4 páginas. Console table
Imprimir página
2
36"
30-3/4"
Position hanger according to Step 1, making sure its center is aligned with the waste hole centerline (Fig. 1). Mark
the hanger screw locations through its mounting holes. Drill pilot holes in positioning screw slots of hanger (Fig. 2).
3
We recommend using two people for installation.
1. Affix hanger to wall (hand tighten only).
2. Move console table legs into approximate position against
the wall.
3. Mount lavatory on bracket making sure the front leg
grommets of console recess into the holes on the underside
of the lavatory.
4. Mark the bottom anchor screw holes in the lavatory.
5. With a pencil, mark the floor around each foot of the console
table.
6. Remove the lavatory and the console table legs.
7. Tighten the hanger positioning screws and drill pilot holes for
bracket mounting screws and lavatory anchor screws. Install
and tighten the bracket mounting screws.
8. Use 1/4" drill bit and drill holes marked on finished floor at
least 1/8" deep.
4
Following manufacturer's instructions, install faucet and drain assembly.
(Not included). Be certain to apply a bead of sealing putty on the underside
of the drain in order to ensure a watertight seal between the
lavatory and drain. Remove excess putty after installing drain on lavatory.
Move console table
previously drilled in the floor in Step 3. Return the fitted lavatory to the
installed position. Level the lavatory by using the adjustable feet and the
rear leg adjustment bumper on the console table legs.
4
5
Connect the trap to drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg
of the trap (area "C").
Secure lavatory on hanger as shown in Step 3. Insert and tighten anchor
screws. Connect hot and cold supply lines to the shut-off valves. Tighten trap
joints for watertight assembly. Apply a bead of caulk around the edge which
contacts the wall as shown. Insert the oval glass shelf onto the shelf support of
the console table legs.
HANGER
HOLES FOR
ANCHOR
SCREWS
IN BACK
DRAPERY
C/L
SUPPLIES AS
REQUIRED
WASTE
FINISHED FLOOR
Fig. 1
legs
in place and position the feet in the holes
MOUNTING SCREW
*C/L OF
HANGER
ANCHORING
SLOTS
Lavatory
- 3 -
HOLES (4)
POSITIONING
SCREW SLOTS (2)
Fig. 2
Steel
Hanger
Mounting
Screw
Hanger
Positioning
Screw
Front Leg
Grommet
of Console
Table
B
Anchor Screw
in Lavatory
Feet are
adjustable
Rear Leg
Adjustment
Bumper
C
7 3 0 5 2 0 - 1 0 0 Re v. D