American Standard Wall Hung Bathroom Sink Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Mobiliário de interior American Standard Wall Hung Bathroom Sink. American Standard Wall Hung Bathroom Sink 2 páginas. American standard wall hung bathroom sink installation instructions

Imprimir página

Affix hanger to wall (hand tighten only). Mount lavatory for

positioning, level the deck, and mark bottom anchor screw

holes (if applicable). Remove lavatory, tighten the hanger

positioning screws and drill pilot holes for anchor screws

and 4 mounting screws. Install and tighten the mounting

screws.

Lavatory

Following manufacturers instructions, install faucet and

drain assembly. (Not included). Be certain to apply a

bead of sealing putty on the underside of the drain (Part

"A") in order to ensure a watertight seal between the

lavatory and drain. Remove excess putty after installing

drain on lavatory.

If inspection of this American Standard plumbing product, within one year after its initial installation, confirms that it is defective in

materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model.

This limited warranty does not apply to local building code compliance; since local building codes vary considerably, the purchaser

of this product should check with a local building or plumbing contractor to insure local code compliance before installation.

This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty

maintenance, abuse, misuse, accident or other damage; if it was not installed in accordance with American Standard's instructions; or if it

has been modified in a manner inconsistent with the product as shipped by American Standard.

American Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of removal

or installation, nor shall American Standard be responsible for any other incidental or consequential damages attributable to a

product defect or to the repair or exchange of a defective product, all of which are expressly excluded from this warranty. (Some

states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to you.)

This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to

province, in which case this warranty does not affect such statutory rights.

For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the

product was purchased, or that a service request (including a description of the product model and of the defect) be sent to the following

address:

In the United States:

American Standard, Inc.

One Centennial Ave.

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

Toll Free: (800) 442-1902

Steel

Hanger

Mounting

Screw

Positioning

Screw

Anchor Screw

(if used)

AMERICAN STANDARD ONE-YEAR LIMITED WARRANTY

Return the fitted lavatory to the installed position.

Connect trap to drain assembly hand tight to check

alignment. It may be necessary to cut off part of the

tailpiece (area "B") or part of the horizontal leg of the

trap (area "C").

Secure lavatory on hanger as shown in 5. Insert and

tighten anchor screws if applicable. Connect hot and

cold supply lines to the shut-off valves. Tighten trap

joints for watertight assembly. Apply a bead of caulk

around the edge which contacts the wall as shown.

In Canada:

American Standard, Inc.

2480 Stanfield Rd.,

Mississauga, Ontario

Canada L4Y 1S2

Toll Free: (800) 387-0369

Caulk

Shut-off

Valves

Saniwares

In Mexico:

Customer Service Manager

American Standard, Inc.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

730427-100 Rev. B