American Standard Enfield 2742.222 Manual de instruções de instalação - Página 7
Procurar online ou descarregar pdf Manual de instruções de instalação para Banheiras American Standard Enfield 2742.222. American Standard Enfield 2742.222 8 páginas. Durabond construction high gloss acrylic fittings not included
Imprimir página
BATH FILLER SUPPLIES
MODEL 9117.012
To ensure this product is installed properly, please
read these instructions carefully before you begin.
DESCRIPTION
Bath Filler Supplies, Model 9117.012, includes 6" deck mount
supply adapters, riser tubes, couplings, shutoff valves, and all
fittings and supports needed to install and connect the 9116
Series Bath Filler to the water supplies.
Adjust centerline spacing of supports and water supply lines
as needed to accommodate American Standard 9116 Series
Bath Filler. Please refer to Bath Filler Installation Instructions
for this dimension.
RECOMMENDED TOOLS AND MATERIALS
Hacksaw/Tubing Cutter
Phillips Screwdriver
Slotted-Head Screwdriver
Tape Measure
DO NOT USE PIPE DOPE FOR THREADED CONNECTIONS AS FINISH DETERIORATION MAY RESULT.
INSTALLATION MUST COMPLY WITH APPLICABLE LOCAL PLUMBING/BUILDING CODES
5" DECK MOUNT
ADAPTER
DECK MOUNT
WASHER
INSTALLATION PROCEDURES
Step 1. Locate and mark correct centerline dimension for Bath Filler on bath deck per roughing-in dimensions on installation instructions supplied
with bath. (Plan Ahead, be sure that floor joists do not interfere with water supply lines or drain connections!)
Step 2. Extend hole centerlines from bath to floor using Plumb Bob.
Step 3. Drill 1" diameter holes for supply risers at locations marked in step 2.
NOTE: Water supplies are primarily factory assembled and water tested. DO NOT attempt to disassemble supplies, as surface may be
damaged and warranty will be void.
Step 4. Assemble floor escutcheons and base flange to short pipe on supply risers. Insert supply risers into floor mounting holes (with shutoff valves
facing outward) and loosely install flat washers and locknuts on pipe nipples from beneath floor.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c .
© A m e r i c a n S t a n d a r d I n c . 2 0 0 4
INSTALLATION
INSTRUCTIONS
Drill, misc. bits
1" Hole Saw or Spade Bit
Open-end Adjustable
Wrench Torpedo
GASKET
UNION
NIPPLE
FLANGE
NUT
UNION
Pipe
Teflon Tape (pipe sealant) or
Wrench
Teflon Based Pipe Sealant
Level
Clear Silicone Sealant
Plumb Bob
SUPPLY
RISER
ESCUTCHEON
VALVE
HANDLE
COVER
FLANGE
NUT
WASHER
FLANGE
FLOOR
SCREWS
FLOOR
SCREW
FLANGE
Assembly
75287 0 - 1 0 0 Re v. A