American Standard Rondo Whirlpool 7242.028W Especificações - Página 2
Procurar online ou descarregar pdf Especificações para Banheiras American Standard Rondo Whirlpool 7242.028W. American Standard Rondo Whirlpool 7242.028W 2 páginas. American standard whirlpool specification sheet
Imprimir página
RECOMMENDED FITTING
LOCATION 64 X 279mm
(2-1/2 X 11)
267mm
(10-1/2)
1067mm
(42)
PROVIDE ACCESS
TO PUMP FOR SERVICE
ON ALL INSTALLATIONS
C/L OF
OVERFLOW
95mm
(3-3/4)
83mm
(3-1/4)
38mm
(1-1/2)
GENERAL SPECIFICATIONS FOR 7242 WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
SYSTEM II PUMP
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR
PENINSULA TYPE INSTALLATION. SUPPORT OF BATH BY INTEGRAL FEET. NO ADDITIONAL
SUPPORT REQUIRED. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL
INFORMATION.
CUTOUT TEMPLATE PROVIDED IN SHIPPING BOX, MAY BE REQUESTED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
FITTINGS AND TWIST GRAB BAR NO. 750565-000 NOT INCLUDED, MUST BE ORDERED
SEPARATELY.
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR
I N TE R FE R E NC E W ITH C IR C U LAT IN G SYS T EM PI PING , DR AIN O VERF LOW , AN D APRO N
INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.
ON SYSTEM II: CONTROL MODULE TO BE MOUNTED BEHIND ACCESS PANEL, A MINIMUM OF
152mm (6) ABOVE ROUGH FLOOR.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances
established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of
superseded or voided leaflet.
1816mm
(71-1/2)
165mm
(6-1/2)
76mm
(3)
229 X 305mm
(9 X 12)
CUTOUT
PUMP
ON/OFF
SWITCH
OUTLINE OF
CUTOUT
SAFE-T-HEATER
REMOVABLE BLANK
38 mm (1-1/2)
TAILPIECE
71-1/2 x 42 x 21-1/2 In (1816 x 1067 x 546mm)
45 x 25 In. (1143 x 635mm)
60 x 30 In. (1524 x 762mm)
39 Lbs./Sq.Ft. (191 Kgs./Sq.m)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
2.1 HP, 15.6 AMPS,120.
© 2003 American Standard Inc.
RONDO™ WHIRLPOOL
HIGH GLOSS ACRYLIC
908mm
(35-3/4)
C/L OF DRAIN
LEVELING STRINGER
NOT FOR SUPPORT
51mm
(2)
495mm
(19-1/2)
546mm
(21-1/2)
ROUGH
FLOOR
INTEGRAL
FEET
94 Lbs.(43 Kg.)
818 Lbs.(371 Kg.)
87 Gal. (330 L)
67 Gal. (254 L)
14-7/8 In (378mm)
30.3
58.7