Da-Lite ADVANTAGE ELECTROL Livro de instruções - Página 8
Procurar online ou descarregar pdf Livro de instruções para Ecrã de projeção Da-Lite ADVANTAGE ELECTROL. Da-Lite ADVANTAGE ELECTROL 12 páginas. Tensioned large
Também para Da-Lite ADVANTAGE ELECTROL: Livro de instruções (12 páginas), Livro de instruções (12 páginas), Manual do instalador (2 páginas), Livro de instruções (4 páginas), Livro de instruções (16 páginas)
Imprimir página
Troubleshooting
Visit www.da-lite.com/products/tutorials.php to find installation
and troubleshooting tutorials. You will also find a link to Live
Chat for interactive support.
Symptom
Screen will not operate
and motor does not hum.
Screen will not operate
and motor does not hum.
Power at junction box.
Screen does not stop
at correct position.
Noise.
NOTE: Screen will operate
with a low pitched hum.
Coasting.
Fabric hangs crooked.
8
Cause
Incorrect line voltage.
Blown fuse.
Tripped circuit breaker.
No power to operating switch
or junction.
Thermal overload tripped.
Broken wire in the "down" or "up" position.
Defective motor, limit switch or capacitor.
Capacitor burned out.
Limit switch out of adjustment.
Squeaking, rubber end plug rubbing on motor.
Grinding. Foreign object in screen
rubbing on roller or fabric.
Gear noise.
Defective brake.
Screen not installed properly.
Fabric has backed up inside case.
Fabric is damaged.
You can contact us by email at [email protected] or by phone
at 800.622.3737 or 574.267.8101 with any additional
troubleshooting questions.
Solution
Verify 115-125V (or 220-240V). If insufficient voltage, rewire
incoming electric line.
Replace fuse.
Reset circuit breaker.
Check above. Tighten all loose wire connections.
Correct any improper connections.
Down Position
Check for power across black and white leads.
Up Position
Check for power across red and white leads.
Let motor cool down for 15 minutes. Try again.
Check for continuity. Cut off old splice and reconnect.
Replace motor assembly. NOTE: Motor is a sealed assembly.
Replace motor assembly.
See Screen Adjustment section.
Center roller in case.
Remove.
Replace motor assembly.
Replace motor assembly.
Check for level and plumb.
Adjust "down" limit switch slowly until roller is exposed and
wrinkle comes out, then readjust for proper drop.
Replace fabric.