Da-Lite Contour Electrol Livro de instruções - Página 3
Procurar online ou descarregar pdf Livro de instruções para Ecrã de projeção Da-Lite Contour Electrol. Da-Lite Contour Electrol 8 páginas. Installer friendly features
Também para Da-Lite Contour Electrol: Livro de instruções (13 páginas), Livro de instruções (9 páginas), Manual do instalador (2 páginas), Livro de instruções (4 páginas), Livro de instruções (8 páginas)
Imprimir página
INSTALLATION
Carefully unpack screen and remove outer wrapping
from case.
Remove the black tape from the slat bar after the case
has been installed.
There are three ways to install the Designer Contour
Electrol: Wall Mount, Ceiling Mount, or Ceiling Hook.
Procedures for each method are as follows:
Wall Mount
1. Secure the wall mount brackets to the wall at the
desired height. Brackets should be fastened to
wall studs or some reinforcement within the wall.
Concrete or brick walls require special fasteners
and anchors.
2. Make sure the brackets are in line and level. See
figure 1 for reference dimensions.
3. Keep in mind you will need at least 5/8" between
the ceiling and the top of the wall mount bracket
to be able to position the case on the bracket.
4. Mount the screen case on the wall bracket as
shown in figure 1. Be sure the case is fully seated
on the bracket. Tighten the stop screws against
the wall brackets.
Ceiling Mount
1. Be sure the ceiling has adequate reinforcement to
attach the screen brackets.
2. The top of the screen case has a channel that the
ceiling mount brackets slide into. Remove the end
cap on the right end of the case and insert the
brackets into the case channel. Lock the brackets
in place by tightening two set screws. Refer to
figure 2.
3. Hold the screen case up to the ceiling and mark
the hole locations. Drill holes into the ceiling and
attach screen with the appropriate fasteners for
your ceiling.
Ceiling Hook
1. Be sure the ceiling has adequate reinforcement to
attach a hook anchor.
2. The top of the screen case has a channel that the
ceiling hook brackets slide into. Remove the end
cap on the right end of the case and insert the
brackets into the case channel. Lock the brackets
in place by tightening two set screws. Refer to
figure 3.
3. The brackets can be attached anywhere along the
length of the case.
4. Attach an S-hook to the large center hole on the
bracket.
4-5/8"
STOP SCREW
2
CASE HOOK
4-1/4"
5/16"
WALL
MOUNT
BRACKET
FIGURE 1
SET SCREWS (2)
CEILING
MOUNT
HOLES
FIGURE 2
SET SCREWS (2)
HOOK MOUNT
HOLE
FIGURE 3
9/16"
ENDCAP
SCREWS
(3)
ENDCAP
ENDCAP
SCREWS
(3)
ENDCAP