American Standard Advanced Clean 3.0 SpaLet Manual de instalação - Página 16
Procurar online ou descarregar pdf Manual de instalação para Casas de banho American Standard Advanced Clean 3.0 SpaLet. American Standard Advanced Clean 3.0 SpaLet 18 páginas. Bidet seat
Imprimir página
[Note 7-1]
● Ensure to install the batteries in the correct
direction (note the negative and positive).
● Do not mix old and new batteries.
● Use the supplied batteries.
When multiple SpaLet seats are installed, a SpaLet seat in other booth may also respond to the signal and
cause malfunction. To prevent this, you can change the signal using the remote control unit you purchased.
Change both the emitting signal (remote control unit) and receiving signal (SpaLet seat).
1. Changing emitting signal (remote
control unit)
(1) Remove the batteries from the remote control
unit.
(2) Refer to the signal table on the right, hold
down the desired button, insert the batteries
and wait for six seconds (twenty seconds for
Cleansing and Bidet button) with the button
held down.
(3) When the emitting signal has been changed,
the battery mark on the lower right of the re-
mote control flashes.
(The number of flashes differs depending on
the signal that has been changed.)
Signal
Operation Button
Number
Signal 1
Water Temp
Signal 2
Seat Temp
Signal 3
Power save
Signal 0
Nozzle Cleaning
Signal 4
Spray Strength -
Signal 5 Spray Strength +
Signal 6
Cleansing
Signal 7
Bidet
* Signal 0 is the default setting.
When multiple SpaLet
Battery Mark
No. of Flashes
Once
Twice
Three times
Four times
Five times
Six times
Seven times
Eight times
-16 - EN-
[Note 7-2]
● Ensure that there is enough space above the remote
control installation position to allow easy removal
and mount of the remote control (see the figure
below).
®
seat units are installed:
2. Changing receiving signal
(SpaLet seat)
(1) Remove the power plug of the SpaLet seat for
which the signal is to be changed.
(2) Insert the power plug again, and then press
the [Stop] button at least 10 times within 10
seconds after insertion.
NOTE: Do not turn on and off the indoor (equip-
ment) breaker to perform the above operation.
* If power is turned on simultaneously for multiple
SpaLet seats, the receiving signal of other bidets
may be changed.
* Some signals cannot be set on some products.
Remote control space
270 mm
80 mm