Da-Lite IMAGER Livro de instruções - Página 3

Procurar online ou descarregar pdf Livro de instruções para Ecrã de projeção Da-Lite IMAGER. Da-Lite IMAGER 6 páginas.

SETTING UP YOUR SCREEN

TOOLS REQUIRED:

Phillips Screwdriver

Carpenter's Level

Tape Measure

FRAME ASSEMBLY

1. Place the four frame pieces on a clean floor.

2. Slide the frame pieces together at corners. (Note: Frame assembly holes may not appear to fit properly at the corners

until all fasteners have been attached. Once fasteners are attached, the frame corners will be drawn in for a proper fit.)

Secure frame pieces with #10 screws provided. Do not tighten screws until all are started, then tighten. See Figure 1.

3. Tighten the two screws at each corner. Do not over-tighten

the screws.

4. Insert and tighten the snap stud in the center of the corner

bracket (Figure 1).

ATTACH THE VIEWING SURFACE

Unroll the screen on a clean surface. Do not use newspaper.

The viewing side is rolled to the inside of the roll. Place the

frame over the screen surface, and while lifting the frame with

one hand, snap the screen surface onto the frame with the

other hand while maintaining a steady pull on the surface.

METHOD 1 (SCREENS 80" AND SMALLER IN VIEWING WIDTH)

Method 1

1. Secure the large wall bracket to wall studs at the desired height. Make sure the bracket is level. The top of the frame

will be 1/8" above the top of the wall bracket when mounted. You will need at least 5/8" clearance above the bracket

to hang the screen. Figures 2, 3, and 4 show the proper orientation for the supplied wall brackets.

2. To install the small wall bracket, you must measure the overall height of the screen frame and subtract 1-3/8". Using

that dimension, measure down from the top edge of the wall bracket and mark the wall for two screw holes. The

holes should be centered within the frame and 6" apart. Refer to Figure 3.

3. Attach the small wall bracket to the wall. Refer to Figure 4 for proper orientation. Do not tighten the screws

completely. The bracket should slide up and down easily.

4. Hang the screen on the brackets by hooking the bottom of

the frame onto the small wall bracket and lift up until you

can hook the top of the frame on the top large bracket.

Push down on the frame to seat it on the brackets. Refer to

Figure 4.

FIGURE 1

FIGURE 2

LARGE WALL

BRACKET

1-PIECE

SMALL WALL BRACKET

1-PIECE