Da-Lite 22951 Manual de instruções de instalação - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação para Acessórios para projectores Da-Lite 22951. Da-Lite 22951 12 páginas. Idea interactive rear projector cart
Imprimir página22516/22951
Assembly And Installation
Cart Assembly
1.
Use eight 5/16-18 x 2 1/2" button head cap screws (W) and
eight 5/16" washers (Y) to secure two side columns (H) to
leg and cross bar assembly (B). (See Figure 1)
(H) x 2
(Y) x 8
1
(W) x 8
Figure 1
IMPORTANT ! : If using side columns (H) for cable
management, install cable clips (P) to side columns prior
to installing column extenders to side columns. Square
nuts (V) will not be able to slide along the full channels if
extenders are already attached. See Cable Management
section for side column cable management installation
instructions.
2.
Slide two column extenders (J and K) over side columns
(H). (See Figure 2)
NOTE:
Make sure right column extender (J) is installed over
right column and left column extender (K) is installed
over left column.
3.
Line up holes on extenders with holes on side columns at
desired mounting height. (See Figure 2)
IMPORTANT ! : Setting the mounting height at this point
is much easier than adjusting it after the screen has been
installed. Make sure column extenders are set at desired
height prior to installing screws in the next step.
4.
Use two #10-24 x 3/8" Phillips pan machine screws (BB) to
secure each column extender (J and K) to corresponding
side column (H). (See Figure 2)
6
(B)
2
4
Figure 2
5.
Hang screen tray and cross assembly (D) onto studs on
column extenders (J and K). (See Figure 3)
6.
Use four #10-24 Phillips pan machine screws (BB) to
secure screen tray and cross assembly (D) to column
extenders (J and K). (See Figure 3)
(rear view)
Figure 3
Installation Instructions
(BB) x 4
2
studs on
5
extenders
6
(BB) x 4