COSMOPOLIT N
ELECTROL
®
Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box
located on the left end of the screen case.
See wiring diagram below for wire connections.
NOTE: This screen can only be controlled by a single 120VAC or 240VAC wall switch. To use multiple switches, an optional low
voltage control must be used.
120V WIRING DIAGRAM
FOR STANDARD
WALL SWITCH
JUNCTION BOX
LOCATED IN LEFT
ENDCAP
SPDT SWITCH WITH
AC (COMMON)
CENTER OFF
BLACK
UP
AC HOT 120VAC 60HZ 1 AMP
OFF
BLACK/YELLOW
RED
DOWN
NOTE: A SINGLE SWITCH CANNOT BE USED TO OPERATE MORE THAN
ONE SCREEN. CONTACT THE FACTORY FOR FURTHER
THIS SWITCH CAN NOT
INFORMATION.
BE USED WITH LVC.
SCREEN DJUSTMENT FOR SCREENS WITHOUT
Screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory.
No further adjustment is necessary.
If you need to make minor stop position adjustments see the appropriate step below.
SETTING THE DOWN LIMIT POSITION
NOTE: One turn of the limit screw equals approximately 2" of screen travel.
TO REDUCE SCREEN DROP:
Turn the down limit switch screw clockwise to decrease the
amount of screen drop. Run the screen down to test the stop
position. If the screen drops too far, raise the screen about one foot
and adjust the limit switch again. Repeat until the desired position
is set.
TO INCREASE SCREEN DROP:
Turn the down limit switch screw counterclockwise to increase the amount of screen drop. Run the screen down
to test the stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit
switch again. Repeat until the desired position is set. Do not adjust for more drop than what was ordered. At least
1-1/2 wraps of fabric must remain on the roller.
INST LL TION FOR SCREENS WITHOUT
®
WHITE
BLACK
MOTOR
RED
GREEN
BUILT-IN LOW VOLT GE CONTROL
240 VOLT WIRING DIAGRAM
FOR STANDARD WALL SWITCH:
Da-Lite offers two styles of 240 volt
wall switches for standard operation.
Please see wiring diagram included in
wall switch box included with screen.
BUILT-IN LOW VOLT GE CONTROL
DOWN LIMIT
SWITCH
ACCESS HOLE
2
UP LIMIT SWITCH ACCESS
THROUGH CASE OPENING
FIGURE 3
Imprimir página