American Standard COMPACT CADET 3 Instruções de instalação - Página 4

Procurar online ou descarregar pdf Instruções de instalação para Casas de banho American Standard COMPACT CADET 3. American Standard COMPACT CADET 3 4 páginas. One-piece toilet

Imprimir página

American Standard COMPACT CADET 3 Instruções de instalação

LEVER LE

BRAS EN

PREMIER

IMPORTANT: Always

clear sand and rust from

system.

• Make sure water supply is

off. Remove valve TOP by

lifting arm and rotating top

and arm 1/8 turn

counterclockwise, pressing

down slightly on cap.

GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and

workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster

shall not be responsible or liable for any damages caused by products used with Fluidmaster valves

that were not manufactured by Fluidmaster, Inc.

PROBLEM

Does not flush

a. Water supply valve closed.

b. Supply line blocked.

c. Flush valve chain too loose or disconnected.

d. Sand or debris lodged in water control.

Poor or sluggish flush

a. Bowl water level too low.

b. Supply valve partly closed.

c. Partially clogged trapway and/or drain pipe and/or vent.

d. Supply pressure too low.

Toilet leaks

a. Poor supply line connection.

b. Poor bowl to tank/floor connection.

Toilet does not shut off

a. Flush valve chain too tight, holding flush valve open.

b. Flush valve seat and/or flapper worn or deformed.

c. Sand or debris lodged in water control.

If inspection of this American Standard plumbing product, within five years after its initial purchase, confirms that it is defective in materials or workmanship, American Standard will

repair or, at its option, exchange the product for a similar model.

This warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of this product should check with a local building or

plumbing contractor to insure local code compliance before installation.

This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or other

damage; if it was not installed in accordance with American Standard's instructions; or if it has been modified in a manner inconsistent with the product as shipped by American

Standard.

American Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of removal or installation, nor shall American Standard

be responsible for any other incidental or consequential damages attributable to a product defect or to the repair or exchange of a defective product, all of which are

expressly excluded from this warranty. (Some states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to you.)

This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to province, in which case this warranty does not

affect such statutory rights.

For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the product was purchased, or that a service request

(including a description of the product model and of the defect) be sent to the following address:

In the United States:

American Standard Inc.

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

For residents of the United States, warranty information may also be

obtained by calling the following toll free number: (800) 442-1902

www.americanstandard-us.com

• While holding a

• Replace TOP by engaging

container over the

lugs and rotating 1/8 turn

uncapped VALVE to

clockwise. MAKE

prevent splashing, turn

CERTAIN TIP IS TURNED

water supply on and off

TO THE LOCKED

a few times. Leave

POSITION. VALVE MAY

water supply off.

NOT TURN ON IF TOP IS

NOT FULLY TURNED TO

THE LOCKED POSITION.

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE

AMERICAN STANDARD FIVE-YEAR LIMITED WARRANTY

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK

SLOWLY, repeat Step 12.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF

NON-USE, it is a signal you are wasting water because:

• The end of the refill tube is inserted into overflow pipe, below

water level in tank. Attach refill tube to overflow pipe using "S"

clip provided.

• The flush valve is leaking because it's worn, dirty or misaligned

with tank ball or flapper (replace with a new flapper).

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL

OF TANK WATER IS SLOW after valve has been in use for

some time, Fluidmaster Model 242 Replacement Seal may be

needed.

Go to our website at www.fluidmaster.com for more

solutions to toilet problems.

For troubleshooting information please contact:

a. Open valve and allow water to fill tank.

b. Shut off water supply, disconnect supply line, and inspect

all gaskets and washers. Reassemble. Also, see Fluidmaster

maintenance (see step 12).

c. Readjust chain length as required.

d. Shut off water supply. Remove cap and clean per Step 12.

a. Check that refill tube is connected to water control and

inserted into tank overflow without being kinked or damaged.

b. Open supply valve fully. Be sure that proper supply tube size is used.

c. Remove obstruction. Consult a plumber if necessary.

d. Normal supply pressure must be at least 20 psi.

a. Review Step 8 of installation procedure.

b. Review Step 4 through 6 of installation procedure.

a. Readjust chain length as needed. Review step 9.

b. Replace flapper/flush valve assembly, as needed.

c. Shut off water supply. Remove cap and clean per Step 12.

In Canada:

American Standard

2480 Stanfield Rd.

Mississauga, Ontario

Canada L4Y 1S2

Toll Free: (800) 387-0369

www.americanstandard.ca

- 4 -

TROUBLESHOOTING

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675

(949) 728-2000 (800) 631-2011

www.fluidmaster.com

® Registered trademark of Fluidmaster, Inc.

CORRECTIVE ACTION

In Mexico:

Customer Service Manager

Ideal Standard, S.A. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

www.americanstandard.com.mx

73 0 1 1 2 3 - 1 0 0 R e v. A