Da-Lite G-200 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Projetor Da-Lite G-200. Da-Lite G-200 8 páginas.

Imprimir página

LAMP REPLACEMENT

CAUTION: LAMP CAN BE EXTREMELY HOT!

1. Allow the overhead projector to run for four or five

minutes after the lamp burns out. The fan should cool

the burned out lamp and prevent injury when you at-

tempt to replace the lamp.

2. Turn off the projector and disconnect the power cord

from the electrical outlet. Although the G-200 is

equipped with a safety interlock switch that cuts off

current when the projection stage is lifted, it is con-

sidered an additional safety precaution to disconnect

the power cord.

3. Remove the cover lock screw on the side of the unit

and lift up the cover to expose the inside of the pro-

jector. The bracket located near the cooling fan will

hold the lid open (A) (see Fig.2).

4. Hold bulb by the ceramic base and pull it out of the

socket (see Fig. 2).

5. To install a new lamp, hold lamp by the ceramic base

and insert the two pins on the lamp into the matching

holes in the socket.

NOTE: Make sure the lamp is pushed into the socket

completely, otherwise the filament of the lamp will not

be properly located.

6. Close the projector lid, see Fig. 3.

1. Lift up slightly on lid.

2. Pull up on bracket.

3. Lower lid.

NOTE: Replace lamp with type EYB 360 watt 82 volt bulb

only.

G-200 Projection Table

Projection

Distance* (Feet)

Size of Screen

Image from 10" x 10" 46 x 46 55 x 55 63 x 63 72 x 72 80 x 80 89 x 89

slide (inches)**

(14" lens)

*Distance is measured from front of projector to screen.

**All dimensions are ±5%.

CLEANING AND MAINTENANCE

The G-200 overhead projector needs minimal mainte-

nance to keep it operating in peak condition. It is only

necessary to keep the optical elements clean and to re-

place lamps when necessary. Remove dust from optical

elements with a soft, lint-free cloth.

If the elements are very soiled, carefully remove them

and clean with lens tissue or a soft, water-dampened,

lint-free cloth. Dry thoroughly with a lint-free cloth.

Remove dust from the reflector every time the lamp is

changed.

FIG. 2