EKHO EK-WL8-OH Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Acessórios EKHO EK-WL8-OH. EKHO EK-WL8-OH 7 páginas. Wireless multi-sensor sensor

STFV.425238.032-AU-UM rev. 16

PROGRAMMING

The "Prog." button on the device is used for initializing the device on to the system.

Please refer to the translator manual for full instructions on how to add a device to

the system. The device can also be initialized using the "Ekho Configuration" soft-

ware.

INSTALLATION

In order to install the device, the mounting base

should be fixed to the ceiling, the sensor can then be

inserted into the base by rotating the sensor until it

clips into the base

Preferably, the device should be installed away from

metallic objects, doors, and power lines, as they can

cause the communication distance to drop. It is also

important to avoid installing the device near electron-

ics and computer equipment in order to protect them

from potential electromagnetic interference.

INDICATION

The device has a LED which indicates its state according to the following:

LED indication

No indication or green flashes

Yellow flashes every 4 seconds

Red flashes every 2 seconds

When the device is powered up, an automatic calibration process will begin, this

lasts around one minute and is indicated with a red flashing LED.

EK-WL8-OH/AU

WIRELESS MULTI-SENSOR SENSOR

10.08.2020

Device's state

Standby mode

Fault state – low battery or malfunctioning

smoke or thermal sensor

Fire alarm

Page 3 from 7