Air Creation Pixel 200 Manual de instruções e manutenção - Página 4

Procurar online ou descarregar pdf Manual de instruções e manutenção para Bicicleta Air Creation Pixel 200. Air Creation Pixel 200 16 páginas.

III) Instructions for use

a) Retrofits

The Pixel trike is designed to be used with the single-seater wing iFun 13 of our production.

To install a wing of another brand, check all parameters (height, displacement of the control bar,

propeller clearance with keel end) and make sure that there is at least 10cm clearance between

the propeller and the wing structure, in all possible angles of attack and angles of bank with the

hang point in its most forward position.

b) Assembling

Assemble the wing, perform the pre-flight check as indicated in its manual, positioning it on the

nose and into the wind.

Wheel the trike behind the wing and line it up with the keel.

Raise the upper beam, push the hang point into the hang bracket, position the Ø10mm bolt and

install the butterfly nut, tilt the lever back in order to tighten the plates, and secure with the safety

ring.

Slip the back-up fastening cable into the belt loop at the king post, running it once around it. Slip

it through the belt loop again and fasten it to the trike beam. The back-up fastening cable should

be run under the tensioning cables. This operation secures the trike to the wing, also securing the

wing cross-bar tensioning system.

Place the propeller to a horizontal position.

Raise the wing nose in a horizontal position.

Attach the front strut between the aluminum flanges at the top of the upper beam using the bolt

and the butterfly nut.

Pick up the 'A' frame tubes, take hold of the control bar and lift the wing while keeping the trike

from falling over or backwards. The front strut can be fitted into the opening at the front of the

lower beam when the wing is lifted high enough. When alone, rotate the instrument panel (if

equipped) on the seat, sit down on the trike keel facing the 'A' frame, take hold of the control bar,

place it on your knees, raise the wing and fit the front strut as indicated.

Install the upper beam safety bolt at the engine support using the butterfly and safety ring, then

install the front strut fastening bolt to the lower trike beam at the fork. Secure with the safety

ring.

Rotate the instrument panel (if equipped) against the front tube and install the windshield by

means of the 1/4-turn screws.

Install the foam seat upholstery using the Velcro tabs.

Dismantling is carried out in reverse order of the assembling operations.

GDMANPixel-1G

Tél. : 33 (0) 4 75 93 66 66 - Fax : 33 (0) 4 75 35 04 03 - Internet : www.aircreation.fr

AIR CREATION Aérodrome de Lanas - 07200 AUBENAS - France

Version 0010

PAGE : 4