Astivita ASTEC60CERTOP Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Placa de fogão Astivita ASTEC60CERTOP. Astivita ASTEC60CERTOP 11 páginas.

• Always use the correct diameter pan, one that is the same or slightly larger than the hotplate.

• The bottom of the pan must be flat.

• Whenever possible keep the lid on the pan when cooking.

• Avoid over-spill of liquid by reducing the heat when boiling has occurred.

CLEANING THE APPLIANCE

Always allow the appliance to cool down before cleaning to avoid a burn injury.

Do not use caustic or abrasive agents, coarse wire wool or hard tools as these can damage the surface

finish.

Normally, wiping with a soft cloth dampened with hot detergent and drying with a soft cloth is

sufficient but for stubborn marks the following is recommended:

Vitreous Enamel or Stainless Steel parts – use only a cleaner that is recommended for these types of

material – avoid chloride based products (such as bleach).

Glass Ceramic surfaces – if any spillage becomes burnt on, remove with a ceramic glass cleaner or

scraper and clean with a cleaner-conditioner containing silicone.

Do not allow the ceramic glass surface to become scratched or damaged as this could lead to a

hazard.

This appliance must be installed by a competent person in accordance with the current version of the

following UK Regulations and Safety Standards or their European Norm replacements:

Building Regulations (issued by the Department of Environment)

Building Standards (issued by the Scottish Development Department)

IEE Wiring Regulations

Electricity at Work Regulations

POSITIONING THE APPLIANCE

A kitchen unit (depending on size) or 600mm worktop, providing the following minimum distance is

allowed:

- 650mm between the top surface and the underside of any horizontal surface above it.

- 50mm clearance around the appliance and any combustible materials.

The surface of any adjacent unit must be capable of withstanding a minimum temperature rise of

85°C.

1 Cut the aperture to the dimensions shown in the table below or use the template provided on the

packaging.

2 Invert the hob and apply the sealing agent provided to match the outer perimeter edge.

3 If the sealing agent is a strip type, the protective covering must be removed from both sides.

Do not leave a gap in the sealing agent or overlap the thickness.

NOTE: do not use any Silicone based sealant, as this can damage the worktop surface if repairs are

INSTRUCTIONS FOR INSTALLATION