Aston Martin Zygote Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Altifalantes Aston Martin Zygote. Aston Martin Zygote 20 páginas.
Imprimir página
GETTING STARTED
Powering on
As described in "Unpack and plug in" on page 4,
plug the power cord into the back of the Zygote and
plug the power cord into a mains wall. Make sure
to connect the Zygote to an outlet with the correct
voltage. The LED indicator will have a solid red light.
Zygote is now set up, in standby mode and ready to
be powered on. Turn on your Zygote by holding the
LED indicator for more than three seconds. The LED
indicator will flash slowly. When the Zygote is on
the LED goes from flashing to steady light. The colour
shows the selected input.
Powering off
To turn the Zygote off, push and hold the LED
indicator for three seconds. The LED indicator will
have a solid red light. Zygote is now off and in
standby mode.
Sleep mode
After twenty minutes of not receiving an audio signal,
the Zygote enters sleep mode. If connected to Wi-Fi,
the LED indicates sleep mode with a solid purple
light. If not connected to Wi-Fi, the LED show a solid
red light. In sleep mode, an active Airplay, DLNA or
iOS USB mode will wake the Zygote up.
Volume control
The volume control is located on the sensor panel to
the right of the LED indicator. The volume is adjusted
by swiping your finger from left to right the volume
increases. By swiping from right to left, the volume
decreases. See "Illustrations" on page 3.
The LED indicator flashes rapidly when adjusting the
volume:
• Blue
Low volume
• Green
Low-medium volume
• Yellow
Medium volume
• Orange
Medium-high volume
• Red
High volume
Mute
Touching the LED indicator when the Zygote is on
mutes the sound. When muted, the LED flashes slowly
in one of the above-mentioned colours to indicate
the volume setting the Zygote will have when it is
unmuted. The sound is unmuted by touching the LED
indicator once more.
Connect source
The Zygote has three different connections for input
sources located on the backside of the product, as
described in "Illustrations" on page 3:
• 1 x RCA Analogue
• 1 x RCA Digital coaxial
• 1 x USB audio streaming
Changing input
By touching the input selector (see description in
"Illustrations" on page 3), the input changes. It toggles
between four positions, analogue, digital, USB and
wireless.
The LED light indicates the selected source/input as
follows:
• Steady green:
RCA analogue
• Steady yellow:
Digital coaxial
• Steady blue:
USB audio
• Steady white:
Wi-Fi audio & iOS USB audio
When playback is started either from DLNA, Airplay,
or iOS USB, the Zygote will automatically change to
this input.
9