Astor-Bannerman ABW6SP Manual do proprietário e manual de instalação - Página 10
Procurar online ou descarregar pdf Manual do proprietário e manual de instalação para Produto de canalização Astor-Bannerman ABW6SP. Astor-Bannerman ABW6SP 12 páginas. Height adjustable basin
Imprimir página•
Working through the aperture in the base of the cover, support the waste assembly, fit the nut
and seals from the P trap through the front hole in the cover and then connect to the P trap
•
Connect the P Trap to the underside of the basin.
•
Fit the free end of the flexible hose to the waste pipe fitted to the site as part of the pre
installation preparations and secure with a cable tie as shown in the picture on page 5.
Basin viewed from below
Basin viewed from below
Rod
Rod
Adjuster
Adjuster
base and clamp for the rods may be necessary to ensure maximum lift of the waste plug. Access
to the clamp may be gained through the large hole in the base of the white plastic lower cover
Fit the Trunking:
•
Place the bottom edge of the mirror into the lower catches and hold
in a vertical position. Ensure the mirror is fitted centrally. Gently push the uppermost catches
downwards into position such that they retain the mirror in its correct position.
security scews .
•
Test the unit:
•
Operate the handset to raise and lower the basin over the full range of travel to ensure there
is clearance between all moving surfaces. Examine for evidence of leaks correct as necessary,
examine and clean the assembly. Complete the warranty documentation and pass the completed
warranty document to the client.
•
Adjustments to the screw on the pop-up waste plug
•
The hot and cold supply hoses need to be enclosed
within the white self adhesive trunking supplied.
•
Using the handset, raise the assembly to its highest
position
•
Remove the capping from the front of the trunking.
•
Remove the protective film from the self adhesive tape
fitted to the rear of the trunking.
•
Pass the trunking behind the hot and cold supply hoses
taking care to ensure that the self adhesive tape is kept
away from the wall at this time. The top of the trunking
needs to be aligned with the recess in the bottom left
hand side of the rise and fall unit; through which were
passed the supply hoses earlier.
•
Using a level, ensure the
trunking is vertical. Once
aligned, press the self adhesive
tape against the wall to secure
the top of the trunking. Then
press the entire length of the
trunking into position.
•
Fit the capping.
Fit the mirror:
•
Remove the two white plastic
caps from above the top mirror
clips and remove the screws.
Page: 10
Fit the 2
Version : 11-04-016