DoorBird A1091 Series Manual de instalação - Página 10

Procurar online ou descarregar pdf Manual de instalação para Equipamento de laboratório DoorBird A1091 Series. DoorBird A1091 Series 13 páginas. Gigabit poe-injector
Também para DoorBird A1091 Series: Manual de instalação (12 páginas)

Imprimir página

App. The user experience is only as good as your network speed, network

stability and quality of your network components, such as your Internet router

and WiFi access points or WiFi repeaters. Please also make sure that your net-

work components are not older than two years, have been manufactured by a

well-known manufacturer, and have the latest firmware installed.

Should these requirements not be fulfilled, it may happen, for example that

the performance of audio and video is poor or push notifications are delayed

or do not arrive on your smartphone or tablet at all.

Requirements:

High-speed Internet (via landline): DSL, cable or optical fibre

Network: 802.11 b/g/n 2.4 GHz or Ethernet, with DHCP

STEP 1: SWITCHING OFF POWER

Switch off the power to all wires leading to the assembly location, i.e. the door

station, door chime, electric door opener, power supply unit, PoE-Switch /

PoE-Injector etc.

STEP 2: DETERMINING THE ASSEMBLY LOCATION

The device is IP50 certified (not water-proof). Please make sure to put the

device into an appropriate housing if you want to use it outdoors.

The network cable between the device and the product to supply with PoE

and network data can have maximum length of 80 meters/262 feet.

STEP 3: DOWELS AND SCREWS

You can mount the device permanently on a wall or ceiling using appropriate

screws. Please skip this step if you do not want to mount the device permanently.

Press the drilling template of the device against the wall or ceiling at the

desired installation site and mark the boreholes with a pencil. Remove the

drilling template again. Ensure that no cables are to be found in the wall

or ceiling behind the boreholes.

If the wall of the house is not made of wood, you should drill dowel holes

5 mm in diameter in the wall according to the drilling template and then place

the dowels provided into the boreholes. If the wall of the house is made of

wood, dowels are normally not required. There are special dowels for assembling

the device on an insulating wall, e.g. Fischer insulating dowels. Please check with

your insulating material manufacturer regarding which dowels they recommend.