AMERITRON RCS-12 Manual de instruções - Página 13

Procurar online ou descarregar pdf Manual de instruções para Interruptor AMERITRON RCS-12. AMERITRON RCS-12 16 páginas. Automatic antenna switch

Imprimir página

Ameritron RCS-12 Instruction Manual

Setting Relay Switching Delay

With the power switch off, hold the ANT 1 button while switching the RCS-12 power on. This allows the

setting of the relay switching delay. The delay is selected by pressing one of the eight antenna selection

buttons. The delays associated with each button are shown below. The default setting is 50ms (ANT 3).

ANT 1

ANT 2

1 ms

25ms

The currently selected delay will have its associated LED lit and the remaining LEDs will be flashing.

Press the antenna button corresponding to the new delay desired. The selected antenna LED will light and

all the LEDs will flash confirming and saving your selection. The RCS-12 will then continue with normal

operation.

Resetting the RCS-12

Resetting the RCS-12 will clear out any saved settings and set the factory defaults. All saved settings will

be LOST!! To reset the RCS-12, switch the power off. While holding ANT 8, power up the RCS-12. All

the antenna LEDs will light for approximately 5 seconds. They will then flash confirming the unit has

been reset.

Troubleshooting

Problem

All LEDs are flashing on

front panel.

LEDs are flashing

sequentially rapidly.

RCS-12 with Kenwood radio

changes antennas slowly.

Remote Relay box not

selecting or selecting

incorrect antennas.

Transmit LED not lit during

radio transmission

ANT 3

ANT 4

ANT 5

50ms

100ms

250ms

RCS-12 is in automatic mode with no radio connected

Check connection from RCS-12 to radio.

Multiple radios have been connected to the RCS-12.

Only one radio can be connected at a time. Remove all but one of the

radios.

There is not a saved antenna for the current band. Save an antenna for the

band.

There is a one second delay from when the status of the radio changes

until the information is serially sent out to the switch. Because of this, the

RCS-12 will not see a band change until the information has been sent by

the radio. This causes the RCS-12 to change antennas slower with the

Kenwood radios.

Ensure the Output Select (J9, J10, and J11) is set for the correct output for

the relay box. Check to ensure the wiring is connected to the relay box in

the correct order.

Ensure the Amp Key from the radio is connected to the Radio Key In on

the back of the RCS-12 on the Radio Input Jack (Pin 7) or the RCA Jack.

Automatic Antenna Switch

ANT 6

ANT 7

500ms

750ms

Solution

ANT 8