Astralpool HALO HUB Manual de instalação - Página 5
Procurar online ou descarregar pdf Manual de instalação para Equipamento de iluminação Astralpool HALO HUB. Astralpool HALO HUB 12 páginas. Automation expansion module
Imprimir página
HALO
®
HUB
™
Installation Manual
Section 2. System Overview
The Halo Hub is designed to work in conjunction with
a Halo Chlor and can be controlled through the Halo
Chlor's main touchscreen or through the Halo ChlorGo
App.
Only one Halo Hub can be paired to a Halo Chlor.
The Halo Hub is not designed to work in a "stand
alone" mode and cannot be controlled unless it is
paired to a Halo Chlor.
Kit contents
Before starting, check that you have the correct parts
as shown. If any parts are missing or incorrect, please
call your local distributor or technical support at 1300
186 875 for assistance.
Halo Hub kit contents
a.
Halo Hub controller
b.
Screws 8G 3/4 (2)
c.
Masonry plug 8G 25 mm (2)
d.
Mounting bracket
Figure 1.
Kit Contents
Figure 2.
Base View
Section 3. Installation
3.1
Mounting
The Halo Hub must be mounted to a wall using the
steel mounting bracket supplied. The position of the
mounting bracket, relative to the top of the product,
which will aid in setting out the equipment area and
aligning with other Halo products.
Figure 3.
Power Supply Keyhole Mounting (back)
1.
Identify a suitable installation location.
NOTE: The distance between the Halo Hub and the Halo
Chlor should be less than 5 meters and ideally
should be "line of sight" for a reliable connection.
If the chlorinator is housed in an equipment
enclosure, then ideally the Halo Hub should also
be located in the same enclosure.
If in doubt, test the signal strength using a mains
power extension cord to pair the Halo Hub to the
Halo Chlor before mounting the Halo Hub.
2.
Insert the two mounting screws into the wall
bracket, 85 mm apart. Use the two plastic
masonry plugs (provided) if mounting into
masonry.
3.
Hang the Hub on the mounting bracket through
the slots. Ensure the hub drops down into place.
Slide to the right to lock in position.
3.2
Power Connections
Halo Hubs are provided with a 2.8Mtr power cable for
connection to a mains outlet.
The Halo Hub has 2 mains power outlets (GPO 1 and
GPO 2).
The following table indicates the maximum permitted
current draw from each outlet.
Mains GPO
Max Current
Type
20382
10A
Halo Hub
Max Current
Max Total
(GPO 1)
(GPO 2)
(GPO1+2)
9.5A
9.5A
9.5A
5