Astralpool SLX Instruções de instalação - Página 3

Procurar online ou descarregar pdf Instruções de instalação para Iluminação subaquática Astralpool SLX. Astralpool SLX 4 páginas. Underwater niche lights for fibreglass pools
Também para Astralpool SLX: Manual de instruções de instalação e funcionamento (6 páginas), Instruções pormenorizadas (6 páginas), Manual de início rápido (4 páginas), Manual de instruções de instalação (7 páginas)

Imprimir página
Astralpool SLX Instruções de instalação
Installation Instructions
1. Before commencing work, check the fibreglass pane surface roughness. Rough surfaces may need
to be smoothed up by hand or power tools to allow proper water-tightness and adhesion of the silicon
sealant.
2. Cut a circular and uniform hole of 152.5mm diameter in the pool shell approximately 400mm below
the expected water line. To cut the hole, use a jig saw or 6" hole saw tool (run power tool on low rpm)
Do not install deeper than 450mm, as this makes servicing the light difficult.
152.5mm
Note: due to the porosity of the fibreglass wall, it is recommended to use silicone along with the O-ring
provided.
3. Run a small bead of silicone around the inner edge of the niche front lip. Ensure the silicone runs as
one continuous line.
4. Fit the niche through the hole in the pool shell. Ensure the conduit connection point is facing upwards
from the niche.
5. Apply a second heavy bead of silicone to the niche on the outside of the pool wall.
Conduit entry – 20 / 25mm
6. Lightly smear silicone into the O-ring compression recess of the collar nut (item 2030061).
7. Fit the O-ring (item 2030058) to the niche and position it near the wall.
8. Fit the collar nut over the niche and begin to tighten it. As you fasten the nut, allow the silicone to be
pushed against the pool shell wall by the O-ring.
9. Tighten the nut firmly by hand only.
Inst.376 Astral Pool Light Niche For Fibreglass Pool Instructions V10.15
Hole
Pool or Spa wall
Niche
Small silicone bead on inside
face of pool/spa wall
Pool or Spa wall
Large silicone bead on outside
face of pool/spa wall
3