Astralpool SLX Light Engine Manual de instalação - Página 6
Procurar online ou descarregar pdf Manual de instalação para Iluminação subaquática Astralpool SLX Light Engine. Astralpool SLX Light Engine 8 páginas.
Imprimir páginaENGLISH
4.2 Flush Mount Installation
Top Screw Hole
Bottom Tab
Figure 5. SLX Flush Mount - Rear of Light Engine
1. Remove the pre-installed retaining screw from the
top of the mounting plate. Retain this screw for later
use.
2. On the face plate, identify and position the screw
hole at the top and the protruding tab at the bottom.
See Figure 5.
3. Insert the protruding tab into the slot at the bottom
of the mounting plate by holding the light at an angle
to the wall. Verify the fit, then seat the light into the
mounting plate. Re-insert the original retaining screw
to hold the light in position. Do not over-tighten, as
using power tools may cause damage.
4. Before filling the pool, check the light is functioning
by switching it on for a few seconds.
NOTE: Installed in pool wall.
Figure 6. SLX Flush Mount Installation
NOTE: Do not look directly at the light whilst it is operating.
Page 6
AstralPool
SLX Light Engine | Installation Manual
®
Section 5. Existing Pool
Retrofit
The SLX Light has been designed to be compatible with
other light vendors' mounting methods. Installing your
new SLX light will require two main steps:
1. Mount the light into the existing hardware;
2. Join the SLX power cable to the existing power
cable.
5.1 Concrete and Fiberglass
Niche Installation
1. Remove the old light from the concrete or fibreglass
niche.
2. Test fit the new SLX light by following the steps for
Section 4.1, Concrete Pool Installation. If your new
SLX light fits, proceed with the installation. If the
light doesn't fit, please contact AstralPool for further
advice.
NOTE: DO NOT SUBMERGE the SLX light into pool water unless it
has the cable fitted.
3. Follow the steps in Section 5.3, SLX 2.5m Cable
Connection to join the SLX power cable to the
existing power cable.
4. Perform final installation of the SLX light.
5.2 Flush Mount Installation
1. Remove the old light and flush mounting plate from
the pool wall. As SLX lights will fit directly onto some
existing mounting plates, trial fit the SLX light to the
mounting plate.
If the light fits, then the old mounting plates can be
reused if they are in good condition. If the existing
mounting plate can't be used, then it can be used as
a pattern to drill mounting and cable holes in the SLX
mounting plate.
NOTE: DO NOT SUBMERGE the SLX light into pool water unless it
has the cable fitted.
2. Follow Section 4.2, Flush Mount Installation
instructions, which will guide you through installing
your new SLX light.
3. Follow the steps in Section 5.3, SLX 2.5m Cable
Connection to join the SLX power cable to the
existing power cable.
4. Perform final installation of the SLX light.
5.3 SLX 2.5m Cable Connection
1. If necessary, cut off the old connector from the
existing power cable. Trim the supplied SLX power
cable so that, once joined, the new combined
power cable has sufficient length to be able to reach
above the surface of the water. This allows easier
installation and servicing. Excess cable can be
removed if desired.