DoorKing 1620 Series Manual de instalação - Página 14
Procurar online ou descarregar pdf Manual de instalação para Sistemas de controlo DoorKing 1620 Series. DoorKing 1620 Series 20 páginas. Lane barrier
Também para DoorKing 1620 Series: Manual de instalação (16 páginas)
Imprimir página
Install Octagon Arm with Reverse/LED Edge
Install End Cap
Push a screwdriver
through the hole in the
bottom of cap to release
spring while pushing cap
on. Keep pushing cap on
until a "CLICK" is heard,
locking it in place.
Spacer
2
Connect Wire Harness to Arm
Note: Spacer
MUST be in
position when
installing a
reverse edge.
See next page.
Plug in reverse edge.
Red/Blue plugs NOT used.
Use bottom hole on arm bracket to secure cable grip.
IMPORTANT: Allow slack in the wire harness between the
cable grips of at least 13" or more for the rotating arm.
1620-065-K-11-21
1
Install Arm & Reverse Edge (REQUIRED)
S l i
d e
S e
R e
e n
v e r
e x t
s e
E d
p a
g e
g e
.
o n
A r m
Octagon
Arm
Tip: Liquid soap will
help reverse edge
slide on easier.
Reverse Edge
Install Arm Cover
IMPORTANT: Wire harness MUST
remain clear of the rotating arm and
the arm cover to avoid wire chaffing.
IMPORTANT: Choose which side of the operator the arm is mounted on,
remove knock-out and run wire harness accordingly as shown.
N e
S i d
O p
t i o n
Use supplied adhesive
zip tie to secure harness
to bottom of bracket.
Allow arm to protrude
about 1" past the end
of arm bracket. Make
sure arm cover fits
over arm.
a r
e
K n
o c k
b l e
C a
p
G r i
12
Test hub UP and DOWN position
before installing arm bracket.
H u
b
A r m
B r a
c k e
t
F a r
S i d
O p
e
t i o n
K n
o c k
- O u
IMPORTANT: Allow slack in the
wire harness between the cable
grips of at least 13" or more
- O u
for the rotating arm.
t
Drawings NOT to scale.
b l e
C a
p
G r i
b l e
C a
p
G r i
t