Check Settings Screen is Displayed
Check
The screen appears when an IP address was not
obtained automatically due to incorrect network key or
inactive DHCP function.
Check 1
If the network key is incorrect, enter the network key
again and click Connect (A).
•
For details on how to check the network key of the access
point, refer to the manual supplied with the access point or
contact its manufacturer.
Check 2
Make sure that the DHCP function of the access point is active.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
If the DHCP function is inactive, enable the DHCP function of the access point or
specify the IP address of the machine, then click Connect (A).
•
For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
•
To specify the IP address of the machine, click Set IP Address (B), then follow the procedure in
Check 4 of "Set Printer IP Address Screen is Displayed" on page 4.
Glossary
•
Network Key
A password required to set to prevent unauthorized access to communication.
•
DHCP function
A function to automatically assign required information (IP address, etc.) to computers, printers or other
devices connected to the network.
•
IP address
A numerical identification assigned to each computer or network device connected to a network.
Set Printer IP Address Screen is Displayed
Check
Check 1
Make sure that you follow "Connection Checklist" on
page 11, then click Connect (A).
Check 2
Turn off the access point, turn it back on, then click
Connect (A).
A
B
Check 3
When obtaining an IP address automatically, make sure that the DHCP function of the
access point is active.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Enable the DHCP function of the access point, then click Connect (A).
•
For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
Check 4
If the problem is not solved even after following Check 1 to 3, follow the procedure
below to specify the IP address.
1
Select Use next IP address (B).
2
Enter the value you want to specify for each of IP Address, Subnet Mask, and
Default Gateway or Router (C).
3
Click Connect (A).
B
C
A
Imprimir página