Amerlux MESA Instruções de instalação - Página 5

Procurar online ou descarregar pdf Instruções de instalação para Equipamento de iluminação Amerlux MESA. Amerlux MESA 5 páginas. Gyp board ceiling

Imprimir página
AMERLUX
LIGHTING SOLUTIONS
Changing lens and reflector (metal halide only):

CHANGING LENS

1.
REMOVE LENS
HOLDER FROM HOUSING.
2.
COMPRESS LENS CLIP
AND REMOVE.
3.
PLACE IN NEW LENS
AND PUT CLIP BACK ON.
MAKE SURE THE CLIP
HOLDS PROPERLY, AND
IS PRESSED FLUSH
AGAINST LENS.
NOTE: IF CLIP IS
NOT FLUSH ON
LENS, THE LENS
HOLDER MAY NOT
CLOSE PROPERLY.
Amerlux, LLC. - 178 Bauer Drive, Oakland NJ 07436 - T: 973-882-5010 - F: 973-882-2605
R
TM
ADAPT. ABILITY.
REFLECTOR
LENS CLIP
LENS
LENS HOLDER
REFLECTOR
INSTALL-REMOVE TOOL
(AMX P/N 636-0221)
USE TOOL TO GRIP
REFLECTOR CUTOUTS
www.amerlux.com
INSTALLATION INSTRUCTIONS
SHEET #:
689-0353
CHANGING REFLECTOR
HOUSING
Sheet 5 of 5
1.
REMOVE LENS HOLDER
AND LAMP FROM HOUSING.
2.
PRESS THUMBS AGAINST
THE SIDE OF THE REFLECTOR
AND TURN CCW UNTIL
REFLECTOR CUT-OUTS ALIGN
WITH TABS ON HOUSING AND
REFLECTOR CAN BE
REMOVED. IF REFLECTOR
DOES NOT TURN, CAREFULLY
USE A FLAT-HEAD
SCREWDRIVER AND INSERT
INTO CUT-OUTS ON THE SIDE
OF THE REFLECTOR AND
TURN TO LOOSEN.
-or-
USE INSTALL-REMOVE TOOL
AVAILABLE FROM AMERLUX
TO GRIP REFLECTOR
CUT-OUTS AND TURN TO
LOOSEN.
3.
MATCH THE CUT-OUTS ON
THE NEW REFLECTOR WITH
THE TABS ON THE HOUSING.
LET IT FALL INTO PLACE.
PRESS THUMBS ONTO THE
SIDES OF REFLECTOR AND
TURN CW TO LOCK BENEATH
TABS.
NOTE: IF REFLECTOR IS
NOT PLACED IN
CORRECTLY, THE LENS
HOLDER MAY NOT
CLOSE PROPERLY.