FAQs
How to install firmware on the Gen 2 A50 Headset and TX Transmitter
●
To install firmware on your A50 and TxD please go to the following website:
astrogaming.com/firmware
Download both the most recent version of the TxD and headset firmware and locate them in
your PC or Mac.
Once downloaded, plug in the TxD to your computer via the USB. The optical connection is not
required. Using the charging USB, plug your A50 headset into the back of the TxD.
Now that you are hooked up to the PC, run and complete both firmware installations one at a
time. The A50 headset must be plugged into the back of the TxD to update.
NOTE: You will need to re-sync the TxD and headset after the installation is complete. How to
do this is below.
Make sure the A50 headset and TxD are synced together. To do this, turn on the A50. After the
headset is fully on, press and hold the power button on the A50 headset until it begins
flashing white. Once flashing, press and hold the power button on the TxD until it begins to
flash white as well. Both should flash white and return to being red.
A50 Gen 2 One Channel Audio Issue (Xbox One, PS4, PS3, Xbox 360)
●
1.
Make sure the A50 headset and TxD are synced together. To do this, turn on the A50.
After the headset is fully on, press and hold the power button on the A50 headset until
it begins flashing white. Once flashing, press and hold the power button on the TxD
until it begins to flash white as well. Both should flash white and return to being red.
2. Make sure your optical cable is fully plugged into the back of the TX Unit port that
reads "Optical In" and the other end of the cable is plugged firmly into your gaming
console.
3. Next, make sure the volume wheel on the headset is turned up to a reasonable
volume.
4. Ensure that the game voice balance on the right ear cup of the headset is somewhere
in the middle.
A50 Wireless Headset PS FAQs
10
Imprimir página