Dora Metal DM-99006 Manual de instruções - Página 5
Procurar online ou descarregar pdf Manual de instruções para Frigorífico Dora Metal DM-99006. Dora Metal DM-99006 10 páginas. Cooling module
Imprimir páginaEN - DORA METAL Spółka z o.o.
While key lock allows the user to avoid any undesired and potentially hazardous tempering with, if the controller is
installed in a publicly accessible place. To disable key lock, in INFO menu, set LOC=YES parameter. To activate the
keyboard again, set LOC parameter to NO.
Unlock keyboard
- press the
- then, while holding the
- to exit this menu, press the
MOUNTING PRODUCT
Mounting sequence:
1. Before foamed housing is mounted, bond discharge pipe in granite plate.
2. Spread thermal-conductivity compound evenly over the aluminium plate,
leaving 20mm space from edge of the plate.
3. Apply adhesive on free space of the aluminium plate.
4. Bond the housing to the granite plate and bolt using bolts M6 + serrated
washers.
Place the granite plate with cooling module mounted on a support structure (framing, cabinet, etc.)
Control panel of the device is suitable to be mounted in a support structure or decorative structures.
Dimensions of mounting hole for control panel: 125x75. Make sure to install control panel cover on the
inside.
When encasing devices make sure that adequate ventilation of the unit is provided. In the encasing,
opposite the condenser, drill ventilation (through) holes to ensure free movement of cooling air for the
condenser. The area of holes ensuring free movement of cooling air should not be smaller than the area of
outline of the condenser. Make sure to position the unit at least 25cm from the wall.
PREPARATION FOR STARTUP. CLEANING AND MAINTENANCE
Commissioning and maintenance can be carried out by personnel in charge on condition the below
recommendations are strictly followed. The manufacturer will decline all responsibility for any operations
performed on the device without following recommendations herein.
Before any maintenance works, make sure the device is disconnected from power supply. Do
not remove any protection systems.
Before commissioning remove protective foil. Clean external and internal surfaces using warm water
with degreaser for washing kitchenware, with a soft cloth, following the polished direction, rather than in
Chilling equipment
button until LOC message is displayed,
button, press the
button or wait 10 seconds.
Bolt M6
button.
Granite plate
Foamed housing
Detail A
Adhesive
Serrated washer
Sikaflex-11FC
adhesive
Tube 20x2 L=100
Thermal-conductivity compound
Adhesive
Aluminium plate
5